Évaluations - 5, GPA: 3.8
(
)
)
|
Facilité d'utilisation
To protect against electrical hazards, DO NOT immerse in water or other liquids. 8. DO NOT touch the control panel or plug with a wet hand. 9. DO NOT run cord under carpeting. DO NOT cover cord with throw rugs, runners, or similar coverings. Arrange cord away from traffic area and where it will not be tripped over. 10. DO NOT insert or allow foreign objects to enter any ventilation or exhaust opening as this may cause an electric shock or fire, or damage the heater. 11. To prevent a possible fire, DO NOT block air intakes or exhaust in any manner. DO NOT use on soft surfaces, like a bed, where openings may become blocked. 12. A heater has hot and arcing or sparking parts inside. DO NOT use in areas where gasoline, paint, explosive and/or flammable liquids are used or stored. Keep unit away from heated surfaces and open flames. 13. Avoid the use of an extension cord because the extension cord may overheat and cause a risk of fire. However, if you have to use an extension cord, the cord shall be No16.AWG minimum size and rated not less than 1500W. 14. To avoid fire or shock hazard, plug the unit directly into a 120 V AC electrical outlet. 15. To disconnect heater, turn controls to OFF, then remove plug from outlet. Pull firmly on the plug, DO NOT unplug by pulling on the cord. 16. Always unplug the unit before moving or cleaning, or whenever the heater is not in use. 17. Use only for intended household use as described in this manual. Any other use not recommended by the manufacturer may cause fire, electric shock, or injury to persons. The use of attachments not recommended or sold by unauthorized dealers may cause hazards. 18. Always use on a dry, level surface. 19. DO NOT use outdoors. 20. WARNING: To reduce the risk of fire or electric shock, DO NOT use this unit with any solid-state speed control device. 21. DO NOT attempt to repair or adjust any electrical or mechanical functions on this unit. Doing so will void your warranty. The inside of the unit contains no user serviceable parts. Qualified personnel should perform all servicing only. 22. SAVE THESE INSTRUCTIONS PRODUCT INFORMATION & SPECIFICATIONS Micathermic heating technology combines two popular heating technologies to create the ideal room heater. Using radiant and convection heat, Micathermic heaters are able to achieve full power within minutes and provide a consistent and comfortable silent heat without causing dry spots. Voltage Rating 120 V (60Hz) Power Consumption 750/1500W Unit Size 18 in. (W) x 8 5/8 in. (D) x 26 in. (H) Unit Weight 11 lbs DISCLAIMER ALL INFORMATION AND THE TECHNICAL SPECIFICATIONS PRESENTED IN THIS USER’S MANUAL ARE THE PRESENTATION OF THE MANUFACTURER. SOLEUS INTERNATIONAL HAS NOT CONDUCTED INDEPENDENT TEST TO THE INFORMATION AND THE SPECIFICATIONS PRESENTED HEREWITHIN. SAFETY FEATURES Tip-Over Safety Feature This heater is equipped with a tip-over safety feature. Once the heater is tipped over, an internal switch will automatically shut the heater off. Once the heater is restored to an upright position, the heater will reset. To continue operation, turn on the heater using the supplied remote control or the control panel on the heater. Overheat Safety Feature This heater is equipped with a overheat safety feature. When the heaters internal components reach a certain temperature that could cause overheat and possible fire, the heater will automatically shut off. The heater will automatically reset itself once the internal temperature decreases to acceptable levels. Polarized Plug Warning: This appliance has a polarized plug (one blade is wider than the other). To reduce the risk of electric shock, this plug is intended to fit into a polarized outlet only one way. If the plug does not fit fully into the outlet, reverse the plug. If it still does not fit, contact a qualified electrician. Do not attempt to modify the plug in any way. DO NOT DEFEAT THE SAFETY PURPOSE OF THE POLARIZED PLUG. WARNING: It is normal for the power cord to feel warm to the touch; however, a loose fit between the outlet and the plug may cause overheating of the plug. If this occurs, try inserting the plug into a different outlet. Contact a qualified electrician to inspect the original outlet for damage. IN THE BOX • MICATHERMIC HEATER • REMOTE CONTROL & BATTERY • INSTRUCTION BOOKLET • 2 - WHEEL BASE • 4 - WHEELS • 2 - LARGE GREY WASHERS • 2 - LARGE BLACK SPRING WASHERS • 2 - STANDARD SCREWS • 4 - WHEEL SCREWS • 4 - SMALL BLACK SPRING WASHERS • 4 - SMALL GREY WASHERS CONTROL PANEL CONTROL PANEL PRODUCT DIAGRAM CARRYING HANDLE WHEEL BASE WHEELS ASSEMBLY 1. Remove the heater body, two wheelbases, wheels, screws, and washers from the box. Remove the packaging materials and keep for future storage. 2. Attach the wheels to each wheelbase with the supplied wheel screws, small spring-washers, and small washers. WHEEL BASE WHEEL SCREW WHEEL SMALL SPRING WASHER SMALL WASHER 3. Be certain the heater is unplugged and the controls are set to off. Set the heat...