INTRODUCTION This section provides the installation instructions for the Henny Penny Heated Merchandiser. Installation of this unit should be performed only by a qualified service technician. Do not puncture the heated merchandiser with any objects such as drills or screws as component damage or electrical shock could result. 2-2. UNPACKING The Henny Penny Heated Merchandiser is tested, inspected and expertly packed to ensure arrival at its destination in the best possible condition. The unit ha

ELECTRICAL DATATABLE (Continued) MODEL COMBINATION VOLTS KW AMPS MODEL COMBINATION VOLTS KW AMPS 1 PHASE 3 PHASE1 PHASE 3 PHASE HMR-106 3S/2F* 120/208 5.2 25 17 HMR-105 3F/2S* 120/208 4.2 20 14 (Cont.) 6.7 32 20 (Cont.) 5.5 26 17 120/240 5.2 22 15 120/240 4.2 18 12 7.0 29 18 5.7 24 15 220-240 5.5 23 N/A 220-240 4.5 19 N/A 7.3 31 N/A 6.0 25 N/A 380-415 5.5 N/A 11 380-415 4.5 N/A 8 7.3 N/A 11 6.0 N/A 9 HMR-106 2S/2F/2S 120/208 4.5 21 14 HMR-104 4S 120/208 2.6 13 9 6.0 29 17 3.6 17 11 120/240 4.5 1

Do not puncture the heated merchandiser with any objects such as drills or screws as component damage or electrical shock could result. 2-2. UNPACKING The Henny Penny Heated Merchandiser is tested, inspected and expertly packed to ensure arrival at its destination in the best possible condition. The unit has been bolted to wooden skid. All items have been packed and taped inside of the unit. The unit is then packed inside a triple wall corrugated carton with sufficient padding to withstand norma

CABINET DIMENSIONS 803 2-5 Model HMR-103,104,105,106,107 2-6. CENTER GLASS These are the instructions for installing the center glass on units INSTALLATION that are combination, self-serve and standard merchandisers. 1. Notice the location of the bracket on unit, as indicated. 2. Using a 3/8” socket, or nut driver, loosen the 2 acorn nuts securing the bracket, but do not remove. 3. Slide bracket off from around the 2 acorn nuts. 2-6 1202 Model HMR-103,104,105,106,107 2-6. CENTER GLASS INSTALLATI

(FOR EQUIPMENT WITH CE MARK ONLY!) To prevent electric shock hazard this appliance must be bonded to other appliances or touchable metal surfaces in close proximity to this appliance with an equipotential bonding conductor. This appliance is equipped with an equipotential lug for this purpose. The equipotential lug is marked with the following symbol A separate disconnect switch with proper capacity fuses or breakers must be installed at a convenient location between the unit and the power sourc