Diagram for drilling the hole. Figure 3. Installing resaw fence. 3. Mount the fence assembly on the bandsaw. H7528 Parts Breakdown and List REF PART # DESCRIPTION 1 PH7528001 FENCE (AL) 505MM 1 2 PH7528002 MOVING PLATE 1 3 PW01M FLAT WASHER 8MM 1 4 PH7528004 LOCK KNOB M8-1.25 X 44 1 5 PH7528005 END COVER 148 X 22 X 1 2 6 PHTEK3M TAP SCREW M3.5 X 8 4 COPYRIGHT © JUNE, 2005 BY GRIZZLY INDUSTRIAL, INC. REVISED NOVEMBER, 2006. WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SH

Slowly feed the workpiece into the blade and continue with the cut until the blade is completely through the workpiece. Figure 48 shows a typical ripping operation. Note: If you are cutting narrow pieces, use a push stick to protect your fingers. Figure 48. Example of typical ripping operation with a push stick. Awarning NEVER place fingers or hands in the line of cut. In the event that something unexpected happens, your hands or fingers may slip into the blade. ALWAYS use a push stick when r

Installing the resaw fence on your old fence requires that you drill a hole in your old fence. Inventory (Figure 1) A. Resaw Fence.............................................1 B. Adjustment Handle.....................................1 C. Flat Washer 8mm.......................................1 D. Moving Plate...............................................1 Drilling the Hole Before starting, you should have a pencil, a measuring tape, a center punch, a hammer, a 3/8" drill bit, and access

LE VALVE BUSHING 13 PH8220013 VALVE SPRING 14 PH8220014 AIR STRAINER 15 PH8220015 1/4" NPT MALE AIR FITTING 16 PH8220016 HOUSING ASSEMBLY 17 PSS20M SET SCREW M8-1.25 X 8 18 PH8220018 TRIGGER 19 PH8220019 REVERSE VALVE KNOB 20 PH8220020 TAPERED SCREW M6-1 X 10 21 PH8220021 GASKET 22 PR45M INT RETAINING RING 10MM 23 PH8220023 FRONT ROTOR BEARING R8 24 PH8220024 REAR END PLATE 25 PH8220025 ROTOR 26 PH8220026 ROTOR BLADE 27 PH8220027 CYLINDER DOWEL 4 X 58 28 PH8220028 CYLINDER 29 PH

Make sure that the saddle is centered under the load point. Do not over-extend the load or the load may shift and swing. 3. Slowly lower the component onto the jack stand, making sure that the load point is still centered and all three corners of the stand base are still on the ground. To remove the jack stand, secure or remove the component until the jack stand can be lowered and removed. Remove the jack stand while the vehicle is securely supported. COPYRIGHT © DECEMBER, 2007 BY GRIZZLY IND