Évaluations - 4, GPA: 4
(
)
)
|
Facilité d'utilisation
Prior to the first use following: · Are the circuit breakers on? · Are the light bulbs in your fireplace loose? (to check, follow the instructions for replacing the light bulbs under the maintenance section of this manual) 2. The heater on your fireplace may emit a slight, harmless odor when first used. This odor is a normal condition caused by the initial heating of internal heater parts and will not occur again. 3. The information regarding the model of your fireplace can be found on the rating plate located on the back of the unit. 4. If you have any technical questions or concerns regarding the operation of your fireplace, or require service contact customer service at 1-888-346-7539 before returning the product to the point of purchase. IMPORTANT INSTRUCTIONS PLEASE RETAIN THIS USER’S FUTURE REFERENCE When using electrical appliances, should always be followed to electric shock, and injury to persons, following: 1. Read all instructions before using the Fireplace. 2. The heater is hot when in use. To avoid burns, do not let bare skin touch hot surfaces. The trim around the heater outlet becomes hot during heater operation. Keep combustible materials, such as furniture, pillows, bedding, papers, clothes, and curtains at least 3 feet (0.9m) from the front of the unit. CAUTION: High Temperature, keep electrical cords, drapery, and other furnishings at least 3FT (.9m) from the front of the heater and away from the side and rear. 3. Extreme caution is necessary when any heater is used by or near children or invalids and whenever the unit is left operating and unattended. CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN NO USER- SERVICEABLE PARTS INSIDE 4. Always unplug 5. Do not operate or plug, or if the heater if the fireplace has been damaged in any manner. Return heater to authorized service facility for electrical or mechanical adjustment, 6. Do not use outdoors. 7. The fireplace is not intended for use in bathrooms, laundry areas and similar indoor locations. Never locate heater where it may fall into a bathtub or other water container. 8. Do not run the cord under carpeting. Do not cover cord with throw rugs, runners, or the like. Arrange cord away from traffic area and where it will not be tripped over. 9. To disconnect the unit, turn the controls off, then remove the plug from the outlet. 10. Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this may cause an electric shock or fire, or damage to the heater. 11. To prevent a possible fire, do not block air intake or exhaust in any manner. Do not use on soft surfaces, like a bed, where openings may become blocked. 12. All electrical heaters have hot and arching or sparking parts inside. Do not use in areas where gasoline, paint, or flammable liquids are used or stored or where the unit will be exposed to flammable vapors. 13. Do not modify the fireplace. Use it only as described in this manual. Any other use not 2 recommended cause fire, electric 14. To reduce the risk of electric appliance has a polarized wider than the other). This polarized outlet only one way. If the plug does not fit fully in the outlet, reverse still does not fit, contact a qualified to install the proper outlet. Do not change plug in any way. Avoid the use of an extension cord. Extension cords may overheat and cause a risk of fire. If you must use an extension cord, the cord must be No. 16 AWG minimum size and rated no less than 1875 watts. 15. Do not burn wood or other materials in the fireplace. 16. Do not strike the clear door panel. 17. Always use a certified electrician should new circuits or outlets be required. 18. Always use properly grounded, fused and polarized outlets. 19. Disconnect all power supply before performing any cleaning, maintenance or relocation of the unit. 20. When transporting or storing the unit and cord, keep in a dry place, free from excessive vibration and store so as to avoid damage. SAVE THESE INSTRUCTIONS IMPORTANT INSTRUCTIONS NOTE: Procedures and techniques that are considered important enough to emphasize. CAUTION: Procedures and techniques which, if not carefully followed, will result in damage to the equipment. WARNING: Procedures and techniques which, if not carefully followed, will expose the user to the risk of fire, serious injury, illness or death. If you have any questions about our products please have the catalogue/model and serial numbers available upon calling customer service. The catalogue/model and serial number are located on the back of the unit. Model Number Serial Number 4 NOTE A 15amp, 120 volt circuit is required. A dedicated circuit is essential in all cases. A dedicated circuit will be required if, after installation, or fuse blows on a regular basis operating. Additional appliances on the same circuit may exceed the current rating breaker. WARNING Ensure the power cord is not installed so that pinched or against a sharp edge and ensure that power cord is stored or secured to avoid trippin...