Évaluations - 2, GPA: 5
(
)
)
|
Facilité d'utilisation
NOTE : When operated for the first few times, the appliance will emit some odors and fumes. This is due to the evaporation of oils and solvents used in fabricating the appliance. Close off the room to the rest of the house and open all windows. Keep the room well ventilated. Operate the appliance continuously on high setting for at least 4 to 6 hours. This will ‘burn-in’ the appliance and reduce the chance of odors and fumes reoccurring the next time the appliance is used. WARNING : If you do not follow these instructions exactly, a fire or explosion may result, causing property damage, personal injury or loss of life. This appliance has a pilot which must be lit by hand using the sparker located next A. to the appliance valve controls. When lighting the pilot, follow the start-up procedures exactly. BEFORE LIGHTING, smell all around the appliance area for gas. Be sure to smell B. next to the floor, because some gases are heavier than air and will settle on the floor. IF YOU SMELL GAS, follow the instruction on the front cover of this manual. Use only your hand to push in or turn the gas control knob. Never use tools. If the C. knob will not push in or turn by hand, do not try to repair it. Call a qualified service technician. Force or attempted repair may result in a fire or explosion. Do not use this appliance if any part has been under water. Immediately call a D. qualified service technician to inspect the appliance and to replace any part of the control system and any gas control which has been under water. Marquis 38 INITIAL START UP INSTRUCTIONS Cont.. START-UP PROCEDURE Set the thermostat, if present, to the lowest level. Press slightly and turn the control knob 1. clockwise .. to the OFF position and wait 5 minutes; thus allowing any gases to escape which may have accumulated in the combustion chamber. Note: LP gases do not vent upward. Then follow step 2 and 3 to establish pilot. 2. Press slightly and turn control knob counterclockwise .. to PILOT position; depress control knob and light pilot by repeatedly pressing the sparker. Venting of air may take place at the pilot prior to the flow of fuel gases. Once flame is established, hold knob depressed for approximately 60 sec. Release control knob. If pilot should go out, turn the control knob to OFF position and 3. repeat steps 1, 2 and 3. Note: this will allow reset of INTERLOCK for proper lighting of pilot. 4. Press and turn control knob counterclockwise .. to ON position. Turn thermostat to the desired comfort level or turn ON/OFF switch to the ON position. 5. TEMPORARY SHUT-DOWN PROCEDURE To turn off the main burner only, set the thermostat to the lowest setting or turn remote 6. switch to OFF. Press and turn the control knob clockwise .. to PILOT position. COMPLETE SHUT-DOWN PROCEDURE 7. Press and turn the control knob clockwise .. to the OFF position. Control Knob Marquis 38 MAINTENANCE CAUTION : Only conduct maintenance on a cold appliance. CLEANING THE APPLIANCE The exterior painted surfaces, glass and gold trims may be cleaned with a soft, non-abrasive cloth and water or a suitable, mild, non-abrasive cleaner. Regularly, • Clean and remove any lint accumulations or debris from the grills and in any combustion and convection air passage ways. • Keep the appliance area free from combustible materials, such as paper, wood, clothing, gasoline and flammable solids, liquids and vapors. • Visually check the height and color of the burner and pilot flames. • Check for unusual noise, odor and operation of the appliance. • Check the vent terminal for any damage, or obstruction by plants or debris accumulation. Once a Year, • Remove the glass door and clean the inside of the glass with a soft, non-abrasive cloth and water or a suitable, mild, non-abrasive cleaner. • Carefully remove the logs and gently brush off any loose carbon deposits. This job is best done outside the house, wearing a dust mask.The logs are very fragile, take care not to break them. After cleaning, the logs must be replaced as per the instructions in this manual. • When replacing glass door, ensure the gasket is still secure all around the edge of the glass and it is sealing against the firebox frame. Replace the gasket is worn, damaged or falling off. Once a Year have a qualified service technician, • Completely inspect the appliance and the venting system. • Clean and remove any lint accumulations or debris in the firebox, on the burners, on the pilot, at the primary air opening, on the optional convection air blower and in any combustion and convection air passage ways. • Check the safety system of the gas valve. • Check condition of both glass door gasket and top pressure relief door gasket. Replace if damaged or worn. WARNING : All parts removed or disturbed must be properly replaced after maintenance. Service and repair must be conducted by a qualified service person. If these instructions are not followed, a fire or explosion may result, causing property damage, personal i...
Ce manuel est également adapté pour les modèles :Cheminées - DVR-38 (767.54 kb)