Évaluations - 2, GPA: 4
(
)
)
|
Facilité d'utilisation
ENGLISH 45 How to Use This product is for household use only. GETTING STARTED • Remove all packing material and any stickers from the product. • Remove and save these instructions. • Please go to to register your warranty. • Wash all removable parts as instructed in CARE AND CLEANING section of this manual. B • Open one-piece cover and pour fresh cold water into the water reservoir up to 12-cup (MAX) mark (B). • Place permanent nylon filter or paper 8 – 12 cup basket-style paper filter into filter basket holder (C). • Close one-piece cover. • Make sure the lid of the carafe is in place and place empty carafe on the “Keep Hot” carafe plate. • Pull power cord out of the cord storage in the back of coffeemaker and plug into an outlet. • Brew water through appliance following the BREWING COFFEE instructions – without adding coffee grounds. Note: This removes any dust or residue that may remain in the system during the manufacturing process. • Discard water from the carafe; rinse permanent filter or discard paper filter, if used. • Turn off the appliance, unplug it and allow to cool down. ADJUSTING THE POWER CORD LENGTH Note: You can adjust the length of the power cord to suit your needs. D • To increase the length of the power cord, simply grasp the cord (not the plug) in the rear of the coffeemaker and gently pull down and out of the slot away from the coffeemaker (D). • To decrease the length of the power cord, simply feed any excess cord into the slot in the rear of the coffeemaker. WATER FILTER E 1. Remove carbon filter from packing material. 2. Press latch on filter holder to open (E). 3. Place carbon filter inside. F G 4. Close the filter holder tightly until it snaps into place (F). 5. Place filter holder inside the water reservoir and insert it into the recess at the bottom right hand corner (G). Note: Replace carbon filter every 60 brewing cycles or every 2 months after removing it from the sealed package. Call the 800 number on the front cover for replacements WATER FILTER REPLACEMENT 1. Press latch on filter holder to open (see illustration E). 2. dispose of old carbon filter. 3. Remove new carbon filter from packing material. 4. Place new carbon filter inside filter holder. 5. Close the filter holder tightly until it snaps into place (see illustration F). 6. Place filter holder inside the water reservoir and insert it into the recess at the bottom right hand corner (see illustration G). Note: Replace carbon filter every 60 brewing cycles or every 2 months after removing it from the sealed package. Call the 800 number on the front cover for replacements. SETTING THE CLOCK 1.Plug appliance into standard electrical outlet. 2.The digital clock display flashes 12:00. Note: You must set the clock in order to use the DELAYED BREWING feature. H 3. To change the time: Press HoUR button until the correct time appears (H). Note: When the time passes noon the letters “PM” will appear in the lower right corner of the display to let you know you are in P.M. time. If the PM is not shown in the display, the time is AM. 4. Repeat with the minute (MIN) button. Tip: Hold the buttons down to make the hours and minutes change rapidly after a short delay. To change the time in 1-hour or 1-minute increments, tap the button. Note: If the appliance is unplugged or power is interrupted even momentarily, the time may need to be reset. ENGLISH BREWING COFFEE Note: It is not necessary to set the clock to brew coffee unless you want to use delAYed BREWING. 1. open one-piece cover. 2. Fill water reservoir with desired amount of cold tap water. do not exceed the 12-cup (MAX) level on the water reservoir. Important: There is an overflow hole at the back of the coffeemaker. Be careful not to overfill the water reservoir to avoid leaking onto the counter or work surface. 3. Place permanent filter or an 8 –12 cup basket-style paper filter into the removable filter basket, making sure the filter is centered. 4. Add desired amount of ground coffee. 5. Insert brew basket into brew basket holder following directions in GETTING STARTED. 6. Close one-piece cover. 7. Make sure carafe lid is properly attached to the empty carafe. Close the lid. Note: Coffee may overflow if carafe lid is not properly placed. 8. Place empty carafe on the “Keep Hot” carafe plate. 9. Plug cord into an outlet. J K 10. Select the brew strength desired by pressing the BReW STRENGTH button and selecting one of the 2 levels (J): • REGULAR • STRONG Note: during first use, your coffeemaker is set to brew at REGULAR brew strength. 11. Press oN/oFF button; blue light around the button turns on. Brewing begins oR for delayed brewing set the AUTo function before pressing the oN/oFF button. (See below for delAYed BREWING.) (K). 12. When coffee stops flowing into carafe, the brew cycle is complete. 13. once coffee grounds have cooled, carefully open one-piece cover and, using basket handle, remove and discard used grounds. Close one-piece cover. 14...
Ce manuel est également adapté pour les modèles :Cafetières - CM5050C (1.7 mb)