Évaluations - 2, GPA: 4.5
(
)
)
|
Facilité d'utilisation
The machine will be ready to make steam when the indicator stops blinking and remains lit. • Place a jug with the liquid to be heated under the steam nozzle. • Press and hold the start control within 10 seconds and wait for the steam function to commence. CAUTION: the desired function will be disabled if the start control is not pressed within 10 seconds. It will then be necessary to repeat the procedure. • The steam will continue to spray till the start control is released. MILK FOR CAPPUCCINO: Pour some cold milk (100cc min.) in a deep jug and heat it using steam. Agitate the milk jug a little and wait until the foam is ready (one minute min.). To improve the result gently beat a little the jug on the table after that the foam is ready. 8 PROGRAMMING THE AMOUNT OF COFFEE BEANS TO BE GRINDED • This espresso machine has already been calibrated in factory to dispense the ideal measure of ground coffee for one cup of espresso. • However this quantity of ground coffee can be increased or reduced, then the selected measure is stored. The programmable measure of ground coffee refers to both the espresso selection and to regular coffee selection. • Put the machine on stand-by mode as described. • Keep the start control pressed for 10 seconds. • Some LEDS will flash, working as indicators, (the more are the LEDS illuminated the greater the quantity of coffee). Before adjusting make a note of the original setting so that the machine can be reset to the factory settings if required. • To increase or decrease the quantity of ground coffee just press the “espresso” control to decrease and “regular coffee” control to increase. • Once you have modified the coffee ground quantity, press the start control for 10 seconds and the machine will automatically save the quantity desired and it will return to stand-by mode. CAUTION: the correct grinding time can change if a different kind of coffee is used. If any unpressed coffee powder is found when emptying the “used” coffee drawer, it means that the grinding time is too long and should be decreased. The “exhaust” coffee pods in the “used” coffee drawer can help to achieve a correct regulation of the grinding-time. The coffee pods must to be 1 cm in thickness: this is the correct coffee quantity. If its thickness is lower, it means that the grinding time is too short and should be increased. IMPORTANT: Increasing or decreasing the grinding time can change the coffee taste. A stronger coffee taste and a rich aroma can be obtained by slightly increasing the programmed time. A weaker coffee can be obtained by slightly decreasing the programmed time. 9 PROGRAMMING THE VOLUME OF COFFEE DISPENSED IN THE CUP • The volume of coffee dispensed can be adjusted as desired as follows: • Press the espresso control. • Keep the start control pressed until the programme starts (approximately 5 seconds); the start control LED flashes. • When the desired quantity of coffee has been dispensed, press the start control. The machine will stop the cycle and the coffee measure will be stored automatically on the correspondant selection. 10 IF YOU WISH TO RESET THE STANDARD VALUES RESETTING STANDARD VALUES • This coffee machine is calibrated in the factory to make the optimum Italian espresso, the values set for the espresso coffee distribute 30 cc, the values set for the regular coffee is 80 cc. • if the standard values have to be reset From the stand-by control switch on the machine then press both the on/off and hot-water controls at the same time for 5 seconds. • All the LEDs will briefly illuminate to indicate the factory values have been reset. • Press the ON/OFF control. Each selection will use the factory values. N.B.: Only the quantity of water required for each cup of coffee is reset. The measures of ground coffee will not alter. 11 SIGNAL AND ALARMS WATER REFILL INDICATOR • This machine has a sensor which detects when the water reservoir is empty. the reservoir empty led will illuminate. The machine will not operate until the water reservoir is refilled. VOLUMETER COUNTER FAULT • This machine has a volumeter counter which detects the amount of water distribute by the machine. If the water reservoir is empty or if the volumeter counter is foulty the reservoir empty led will blinking and the machine will not operate. To reset this alarm, please put the machine in stand by mode then turn it on again “USED COFFEE DRAWER FULL”/ COFFEE BEENS REFILL INDICATOR • Every 20 coffee the machine show you that the coffee beans container is empty and that the “used coffee drawer” is full. • When the correspounding led will be illuminated, you must empty the Drip tray and the “used coffee drawer” and refill the coffee beans container. • For instructions on how to empty the “used” coffee drawer, see chapter 13 “CLEANING”. FAULT INDICATOR • The machine incorporates an automatic system that, detecting a fault in operation, will illuminate all the LEDS. Switch OFF the machine and contact the nearest Service Forc...
Ce manuel est également adapté pour les modèles :Cafetières - EBA 60002X (1.86 mb)