Évaluations - 2, GPA: 3.5
(
)
)
|
Facilité d'utilisation
Leave for a while (around 5 minutes) before removing the filter holder is appropriate. 1. After preheating the coffee unit as described above, put a coffee cup under the filter and set the switch to the Brewing position . At this point, hot water flows out from the coffee outlet of the filter. Turn the switch to the Heater position . again when the Ok light * is off. Empty the cup, and detach the filter. 2. Insert the filter basket to the filter holder. Then, put ground coffee into the filter holder and press it with the coffee tamper. NOTE: * The manufacturer has provided two types of filter holder. The smaller one is for the one cup, recommend to hold 6g ground coffee for approximate 30ml espresso; the bigger one is for two cups, recommend to hold 12g ground coffee for approximate 60ml espresso. * Tamping the coffee gives a better quality espresso. If you press too hard, the coffee comes out slowly and the crema is dark in colour. If on the other hand, the coffee is not pressed enough, it will come out too quickly and the crema will be light in colour. * Remove any excess coffee from the filter holder rim and attach the filter holder to the machine. NOTE: Tighten the filter handle to avoid leaks. 4. Place the pre-heated coffee cup underneath the filter holder, where coffee drips via the holes. Unless you need to make two cups of coffee at the same time. 5. When the Ok light is lit, you may turn the switch to the Brewing position .At this point, espresso coffee flows into your cup continuously. Turn the switch to the Heater position when there is enough coffee in your cup. 6. After brewing, turn the switch to OFF position and unplug the coffee maker from the electric socket. 7. After brewing , wait after the product is cool, grip the handle of the filter holder (together with the pressure reducer paddle) and turn the holder from right to left for removal simultaneously turning the clip of the handle over to cover the filter basket firmly. Discard the coffee dregs from the filter basket with moderate force and then clean the filter basket and holder for future use. NOTE: * During the brewing process, do not remove the filter holder from the coffer maker. * When pressing the reducer paddle on the handle the excess pressure in the filter holder will be released to revert accidental pressure release. HOW TO BOIL HOT WATER 1. Mount the filter together with the empty filter holder (or without a filter holder) to the coffee unit as described above. 2. Turn the switch to the Heater position .Wait until the Ok light is lit. 3. Put the cup under the two outlets of the filter to hold the hot water. 4. When the Ok light is lit, turn the switch to the Brew position when hot water will flow into the cup nonstop through the outlets of the filter till the Ok light is off, then turn the switch back to the Heater position. If you need more hot water repeat the above steps when the Ok light is lit again. 5. Turn the switch to the OFF position. Unplug the unit from the mains. NOTE: Do not operate the appliance without water in the tank and always remember to fill the tank when the water level goes below the MIN level. Do not fill exceeding the MAX level on the water tank. HOW TO PREPARE FROTHY MILK FOR CAPPUCCINO 1 . Prepare Espresso following the above mentioned procedures. Prepare a cup and adequate milk. NOTE: chill the milk in refrigerator before use. Do not use hot milk. 2. Turn the selector switch to Steam mode and wait until the Ok light is on. This machine will then automatically detect the required temperature. The Ok light will be on when temperature reaches appropriate level. NOTE: Make sure the steam nozzle is closed when turning the selector switch to Steam mode. 3. Pour adequate cold milk into the cup. 4. Place the cup under the steam nozzle and make sure to bathe the end of steam nozzle into the milk completely. 5. Turn the steam release knob anticlockwise, release the steam to make a layer of foam on the milk. NOTE: * When the steam release knob is turned to ‘’MAX’’, it can not go further but backwards. * Do not force to turn the knob to avoid danger or injury caused by the flow of hot steam. 6. When adequate foam is made, turn the steam release knob clockwise and turn off the power of the machine. 7. Pour adequate hot milk into coffee, a cup of hot coffee with milk is done. 8. Unplug the machine from the socket. 9. Let the machine to cool down, then hold the joint of steam nozzle with one hand, and detach the whole nozzle set with another, rinse the set then assemble back into the unit. BREWING CAPPUCCINO 1. Prepare Espresso coffee, using large cups for Cappuccino (see ‘’HOW TO PREPARE ESPRESSO COFFEE’’ paragraph). 2. Pour the frothed milk into the cups containing the Espresso coffee (see ‘’HOW TO PREPARE HOT MILK FOR CAPPUCCINO” paragraph). 3. Add sugar to taste and, if desired, sprinkle a little powdered chocolate on top of the froth. CLEANING AND MAINTENANCE CLEANING THE ESPRESSO BOILER OUTLET At least twi...
Ce manuel est également adapté pour les modèles :Cafetières - TRENTO 29200 (432.01 kb)