Évaluations - 4, GPA: 4.5 ( )

Fabricant : Philips Taille : 2.07 mb Nom Fichier : Langue d'enseignement:

5 Let the descaling solution sit for about 15-20 minutes with the machine off. 6 Switch on the machine by pressing the ON/OFF button (11). (Fig.21) -Fill up (as described in Section 7 of the manual) two cups of water (about 150 ml each) from the steam / hot water wand. Then turn the machine off by means of the ON/OFF button (11) and leave it off for 3 minutes. 7 Repeat the operations described in step 6 until the water tank is completely empty. 8 (Fig.2) - Rinse the tank and fill it completely with fresh drinking water. 9 Place a container under the filter holder. 10 Switch on the machine by pressing the ON/OFF button (11); turn the selection knob (17) to the " " position and, by means of the fi lter holder, dispense the whole content of the tank. Set the selection knob (17) to the " " position to stop dispensing. 11 (Fig.2) - Fill the tank again with fresh water. (Fig.21) - Place a large enough container under the steam wand (Pannarello). Open the water dispensing knob (3) by turning it counter-clockwise. (Fig.22) - Turn the selection knob (17) to the " " position and dispense the whole content of the tank by means of the steam / hot water wand. 12 (Fig.23) - After dispensing water, set the selection knob (17) to the " " position to stop dispensing. (Fig.24) - Close the water dispensing knob (3) by turning it clockwise. 13 Repeat the operations from point (8) once again for a total of 4 tanks. 14 (Fig.19) -Remove the filter holder from the unit by turning it from right to left and rinse it with fresh drinking water. The descaling cycle is now complete. (Fig.2) - Fill the tank again with fresh water. If necessary, prime the circuit as described in Section 4.5. The descaling solution must be disposed of according to the manufacturer’s instructions and/or regulations in force in the country of use. 11 DISPOSAL - The packing materials can be recycled. - Appliance: Unplug the appliance and cut the power cord. - Deliver the appliance and power cord to a service center or public waste disposal facility. This product complies with eu directive 2002/96/EC. The symbol on the product or on its packaging indicates that this product may not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. For more detailed information about recycling of this product, please contact your local city office, your household waste disposal service or the shop where you purchased the product. • 12 • Problem Possible Causes Solution The machine does not turn on. The machine is not connected to the electrical network. Connect the machine to the electrical network. English The pump is very noisy. No water in the tank. Refill with water (Section 4.4). The coffee is too cold. The "machine ready" light (20) was off while switching the selection knob (17) to the " " position. The filter holder is not inserted for preheating (Section 5). Wait until the "machine ready" light (20) turns on. Preheat the filter holder. The cups are cold. Preheat the cups with hot water. The milk does not froth. Not suitable milk: Powdered milk or low- fat milk has been used. Use only cold, whole milk. It is not possible to prepare a cappuccino. Dirty Pannarello. No steam left in the boiler. Clean the Pannarello as described in Section 9. Prime the circuit (Section 4.5) and repeat the steps described in Section 8. There is too little coffee in the filter Add coffee (Section 5). holder. The grind is too coarse. Use a different blend (Section 6). The coffee is brewed too fast, crema does not form. Coffee is old or not suitable. Use a different blend (Section 6). Old or not suitable pod. Change the pod. One component missing in the filter Make sure that all components are present and holder. properly installed. No water. Refill with water (Section 4.4). The grind is too fine. Use a different blend (Section 6). Coffee pressed in the filter holder. Shake the ground coffee. There is too much coffee in the filter Coffee is not brewed or brewed Reduce the quantity of coffee in the filter holder. holder. in drips only. Knob (3) is open. Close knob (3). The machine has limescale build-up. Descale the machine (Section 10). The filter in the filter holder is clogged. Clean the filter (Section 9). Not suitable pod. Change type of pod. The fi lter holder is incorrectly inserted in Insert the filter holder correctly (Section 5). the brew unit. The upper edge of the filter holder is Clean the rim of the filter holder. dirty. Coffee flows out of the edges. Insert the pod correctly. Make sure it does not The pod is inserted incorrectly. come out of the filter holder. There is too much coffee in the filter Reduce the quantity of coffee using the measuring holder. s...

Téléchargez votre

Pour télécharger, entrez 2 chiffres :