Évaluations - 0, GPA: 0
(
)
)
|
Facilité d'utilisation
Do not place the machine near hot surfaces or naked flames as this may damage or melt the cover. Cleaning Instructions Before cleaning the machine, all switches must be in the “off” position, and the machine must be unplugged from the wall socket. You must wait for the machine to cool down. Never immerse the machine in water. It is strictly forbidden to tamper with the inside of the machine. Sizes in millimetres SAFETY REGULATIONS 22 22 23 SAFETY START-UP Recommended and maintenance To get the best results machine, the following • Place the machine on a flat, • Choose a position that is well-and where a wall socket is easily accessible; • Check that the minimum distances around the machine are as indicated in the diagram. Storage of the machine If the machine is to be left unused for a long period, turn it off and unplug it from the wall socket. Keep in a dry place, out of the reach of children. Cover against dirt and dust. Legend of machine components Water tank Water tank lid Main switch Coffee switch with machine ready light incorporated Steam switch Steam/hot water knob Coffee outlet Steam tube Mains cable Drip tray + grill Repairs/Maintenance If the machine stops is in any way defective or has been it immediately from the Never use a faulty machine. Repairs or alterations must only out by qualified experts. Repairs or alterations must only be out by an authorised service centre. The company will accept no responsibility for damage caused by repairs attempted by unauthorised persons. Fire risks If the machine should catch fire use a carbon dioxide extinguisher. Do not use water or a powder extinguisher. Accessories (the accessories vary depending on the model) “Crema” filter holder Filter for “Crema” filter holder (A single unit for making 1 or 2 cups of coffee) Brass filter holder Single cup filter for brass filter holder Twin cup filter for brass filter holder Coffee measure 4 INSTALLMENT For personal safety regulations” found on 4.1 Packaging The original packaging has been to protect the appliance during transportation. You are recommended to keep it for later use. 4.2 Installment requirements Before installing the machine read the following safety instructions carefully: • Locate the machine in a safe place; • Make sure that it is out of the reach of children; • Do not place the machine on a hot surface or near a naked flame. The machine is now ready to be connected to the house electricity supply. 4.3 Connecting the appliance to the power supply Electricity can be dangerous, so always follow the safety regulations carefully. Never use a faulty cable. Faulty plugs and cables must be changed immediately by authorised personnel. The coffee maker must be connected to a suitable wall socket. The voltage of the appliance has been factory- set. The voltage on the rating plate (positioned on the bottom of the appliance) must correspond to that of your house electricity supply. • Uncoil a length of cable from the cable wind found underneath sufficient for the socket. • Check that the main switch position before inserting wall socket. • Plug the appliance into a wall carrying the correct voltage. 4.4 Filling the water tank • Remove the water tank lid (2). • Lift out the water tank (1), making sure you do not damage any of the tubes inside it. • Rinse and fill the tank with fresh water without overfilling. • Put the water tank back in its right place, making sure that the tubes removed previously are all immersed in water. Warning! The tanks of some models are equipped with a water inflow valve. This valve closes automatically when the tank is removed to prevent water leakage. When putting the tank back, press lightly on it to open the valve. • Put the lid back on the tank. Always fill the tank with fresh, not carbonised water: hot water or other liquids may damage the tank. Do not use the coffee maker without water, always check that there is enough water in the tank. 4.5 Priming Before using the machine for the first time, after the appliance has been left unused for a long period or when the water 2424 25 COFFEE FLOW CHOICE WATER JET and steam have it is necessary prime the machine. • Turn on the main switch the inside will be on. • Point the steam tube (“Pannarello”) over the drip tray. • Open the “ hot water/steam” knob (6), turning it in an anti- clockwise direction and press the coffee switch (4). • Wait until a steady stream of water flows from the tube (“Pannarello”). • Press the coffee switch (4) again and close the “ hot water/steam” knob (6), turning it in a clockwise direction. The machine is now ready to make a perfect cup of coffee. COFFEE FLOW Warning! Do not remove the filter holder by turning it manually in a clockwise direction while the machine is producing coffee. Danger of burning. • During this operation the „machine on“ light inside the coffee switch (4) will go on and off. This is perfectly normal. • Before using the machine, make sure that the “ hot water/stea...