Évaluations - 0, GPA: 0
(
)
)
|
Par ce dispositif a également d'autres instructions :
Ordinateurs - HP ProLiant DL2x170h G6 Server (691.53 kb)
Ordinateurs - HP ProLiant DL2x170h G6 Server (728.29 kb)
Facilité d'utilisation
HP h1000 G6 SFF SAS
Overview
Figure 1 Install the Mini SAS to Mini SAS cable into a 2-Node system
with 16 HDD backplane
Cable Kit
This document contains instructions for installing the Mini SAS to
Mini SAS cable into HP ProLiant DL170h G6 servers. This cable
supports connectivity to SAS or SATA drives from an HP Smart Array
Installation Instructions
Controller. The Mini SAS to Mini SAS cable is used for connecting a
HP Smart Array Controller to a 2.5" Small Form Factor (SFF) Hard
Disk Drive (HDD) cage backplane.
For HP ProLiant DL170h G6
NOTE: For more information on preparing the server for
Servers
installation, refer to the HP ProLiant DL100 Series Server
User Guide included in the Easy Set-up CD.
Kit Contents
•
Mini SAS to Mini SAS cable
•
Installation Instructions
Important Safety Information
NOTE: For a 2-Node system, you need to install P410 into
Refer to the Important Safety Information document included with the
FH/FL or FH/HL slots.
server.
Figure 2 Install the Mini SAS to Mini SAS cable into the bottom
Nodes in a 4-Node system with 16 HDD backplane
WARNING: Electrostatic discharge (ESD) can damage
electronic components. Be sure you are properly
grounded (earthed) before beginning any installation
procedure.
Installation Guidelines
This installation is to be performed by qualified individuals who are
knowledgeable of the procedures, precautions, and hazards
associated with equipment containing hazardous electrical circuits.
Installing the Mini SAS to Mini SAS
Cable
1. Turn off the server and all the peripherals connected to it.
2. Unplug all external cables and AC power cords. If necessary,
Figure 3 Install the Mini SAS to Mini SAS cable into the top Nodes in
label each one to expedite reassembly.
a 4-Node system with 16 HDD backplane
3. Disconnect telecommunication cables to avoid exposure to
shock hazard from ringing voltages.
4. Remove the unit from rack and place on a flat surface.
Legal notices
5. Connect the Mini SAS to Mini SAS cable between the PCIe
card and the connectors on the HDD backplane. (Figure 1 or 2,
© Copyright 2009 Hewlett-Packard Development Company, L.P.
depending on the system category.)
The information contained herein is subject to change without notice. The only
warranties for HP products and services are set forth in the express warranty
statements accompanying such products and services. Nothing herein should
NOTE: Your ProLiant server may be different from what
be construed as constituting an additional warranty. HP shall not be liable for
is shown in the illustrations below.
technical or editorial errors or omissions contained herein.
6. Reinstall the top cover.
7. Reinstall the unit into the rack.
Part number: 572261-001
8. Connect all external cables and the AC power cord to the
July 2009 (First edition)
system.
9. Press the power button on the front panel to turn on the server.
... Ce manuel est également adapté pour les modèles :
Ordinateurs - HP ProLiant DL4x170h G6 Server (617.96 kb)
Ordinateurs - HP ProLiant DL170h G6 Server (617.96 kb)
Ordinateurs - HP ProLiant DL80 Server (617.96 kb)