Évaluations - 3, GPA: 4
(
)
)
|
Facilité d'utilisation
The timer can make the setting in the range from 1-24 hours.Every the button is pressed,indication change is the following sequence: 1- 2 - ........-24- cancel (no indication)- 1. 3. After the setting of the timed switch-off, the digits shown on the display screen will go down by 1 for every elapsed hour. The displayed digits indicate the remaining time prior to the timed switch-off. Set turning on time Set the time for the unit to turn on and when it is time,the air conditioner will automatically start operating. 1. When the air conditioner is in the standby mode, press the TIMER button and the air conditioner will enter the timed switch-on mode. 2.Continuely press the TIMER button to set the needed time for switching on the machine. The timer can make the setting in the range from 1-24 hours.Every the button is pressed,indication change is the following sequence: 1 - 2 - ........-24- cancel (no Indication)- 1. 3. After the setting of the timed switch-on, the digits shown on the display screen will go down by 1 for every elapsed hour. The displayed digits indicate the remaining time prior to the timed switch-on. USER'S MANUAL > Split Wall-Mounted Air Conditioner Releasing procedure When the indication on display screen is 24 hour,press the TIMER button again to delete the timed mode. SLEEP OPERATION Use this mode to reduce operation sound when sleeping,etc. Press the SLEEP button,the air flow sound from the indoor unit is decreased. Press the SLEEP button again can release the mode. NOTE: • Use the sleep mode when you are going to bed.If this mode is used in the day,the capacity is reduced since the ambient temperature is too high.(COOL MODE). • During the operation of cooling,the room temperature will be raised gradually by 2°C(4"F) higher than the setting after the machine begins to operate in the sleeping mode. • During the operation of heating mode,the room temperature will be dropped gradually 5°C(9‘F) lower than the setting after the machine begins to operate in the sleeping mode. REPLACEMENT OF BATTERIES • When the signal from the remote controller becomes weak and the indoor unit can not receive it properiy;orthe indications on the display screen becomes blurred,please slide the back cover and replace with two new batteries. • The positive and negative poles must match the installation positions. • New batteries of the same type have to be used for replacement. • If the remote controller is not to be used for long time,take out the batteries so as to prevent the leakage of the electrolyte from damaging the controller. • If when the remote controller is at abnormal state,you can take out the batteries on the back cover to clear of! the display. [Features of Heating Operations! Basic principles and performances Remote Controller 1 -C CLK button ) It does not work on this model. —( RST button ) This button let computer reset, {push the RST button with the tip of a ball pen, etc) Unload the back Cover Remote Controller 2 O The machines absorb heat from the outdoor air and transfer it indoors so as to heat the room air. The heating capabilities through this principle of heat pump go up/down with the increase/decrease of the temperatures of the outdoor air. O It only needs a fairly short time for such hot air circulation system to raise the room ...
Ce manuel est également adapté pour les modèles :Climatiseurs - Amcoraire AOS090HR (4.59 mb)
Climatiseurs - Amcoraire AOS120HR (4.59 mb)
Climatiseurs - Amcoraire AOS180HR (4.59 mb)
Climatiseurs - Amcoraire AWS090HR (4.59 mb)