|
Facilité d'utilisation
See Fig. 3. Fig. 1 /V ^s. ...J t '• Y I fillip! « u 2/5" Screws Fig. 2 4. Measure the inside window sill width and find the center line as shown in Fig. 4. Fig. 3 Fig. 4 © Installation Instructions / 5. Install the L brackets on the outer sill with the short side of the bracket against the back of the inner sill. Install one L bracket 7.5" to each side of center line. See Fig. 5. 6. Carefully lift the air conditioner and slide it into the open window. Make sure the bottom guide of the unit drops into the notches of the L brackets. When the air conditioner drops into the L brackets, the air conditioner will be centered in window opening as shown in Fig. 6. While steadying the air conditioner, carefully bring the window sash down behind the top channel of the unit, as shown in Fig. 7. Fix top channel to window sash with one 3/4" screw, and fix side curtain frames with four 3/4” screws as shown in Fig.6. 7. If storm window presents interference, fasten a 2" wide wood strip to the inner window sill across the full width of the sill. The wood strip should be thick enough to raise the height of the window sill,so that the unit can be installed without interference from the storm window frame, as show in Fig. 8. Top of wood strip should be approximately 3/4" higher than the storm window frame to help condensation to drain properly to the outside. Install a second wood strip (approximately 17" long by 1i/2"wide and same thickness as first strip) in the center of the outer sill flush against the back of the inner sill. Screw the L brackets into this strip, this will raise the L bracket as shown in Fig. 8. Fig. 5 .Seal About 5 L Bracket Fig.7 Fig.8 Operating Instructions / ► Mechanical control model Power ON will star the air conditioner. OFF will completely shut-off the unit. See Fig.9. Fan Only Rotate the knob dial to the Fan Only mark, the unit will circulate the air without cooling. See Fig.9. Cooler Rotate the knob dial to the Cooler marks, the unit will circulate the air with cooling. To set desired cooling temperature, simply rotate the knob to the appropriate setting. The thermostat will automatically controls the cooling cycle of the air conditioner to maintain room temperature. However, the fan motor will continue to operate after the compressor is completed. See Fig.9. Fan Speed LOW will circulate the air at a minimum speed with cooling or not.Recommended for night-time use. HI will circulate the air at a maximum speed with cooling or not. NOTE: After setting the mode, allow 3 minutes before switching to another mode. Thermostat knob A CAUTION A When using FAN control, turn slowly allowing unit to adjust. When using THERMOSTAT, be sure to allow 3 minutes before changing temperature. Adjusting too quickly may cause an overload resulting in a blown fuse.
Climatiseurs - AW-05CM1FLU (2.88 mb)
Climatiseurs - AW-05CR1FHLU (2.88 mb)
Climatiseurs - AW-05CR1FHLU (2.88 mb)