Évaluations - 2, GPA: 5 ( )

Fabricant : Carrier Taille : 260.31 kb Nom Fichier : Langue d'enseignement:

4. Consumer must pay charges for wiring and installation. 3 • SAFETY INSTRUCTIONS (CONTINUED) The receptacle should be an individual branch circuit used only for this air conditioner. Be sure the electrical service is adequate for the model air conditioner you have chosen. The complete electrical rating of your air conditioner is stated on the name plate located at the unit’s side. Be sure the plug receptacle is close enough for the power cord to reach it. WARNING : An extension cord should not be used with your air conditioner! To minimize shock and fire hazards, proper grounding is important. For your safety and protection,this air conditioner is equipped with a special three-prong grounding plug on the service cord. WARNING : Do not, under any circumstances, cut or remove the grounding prong on the plug. To do so will create a shock hazard. Your air conditioner must be plugged into a properly grounded and polarzied three prong receptacle. Do not use an adapter plug. If the wall receptacle you intend to use will not accept a three-prong plug, or if you are not sure the outlet is adequately grounded or protected by a fuse or circuit breaker, have a qualified electrician install the proper oulet according to the National Electric Code and applicable local code. • BEFORE INSTALLATION Test Run Unit : Plug unit into proper power supply outlet. Refer to operating instructions in this manual for comfortable living. Check all controls for correct operation, then unplug unit. Determine Correct Mounting procedure-Refer to Window Installation or Through the Wall Installation. WARNING : • Moving parts can cause personal injury. Be careful when test-running unit. Do not operate unit with front grille removed . • Be sure to use an exclusive power source. • Contact service man for replacement of power cord. 4 • Step 1 - Prepare Components For Installation Parts for installation are as follows; • SCREW TYPE • Sill Bracket (2 pieces) • Window Kit Left side (Frame ‘L+Shutter) - (1 piece) • Window Kit Right side (Frame ‘R+Shutter) - (1 piece) • Sash Bracket (1 piece) • DRAIN, DRAIN seal • Frame Guide Lower - (2 pieces) • Levelling Screw (Machine M8x45) - (2 pieces) • 1 inch Screw (M5x30) - (4 pieces) • 5/8 inch Screw - (M4x16) - (8 pieces) • DRAIN SCREW (M4x8) - (2 pieces) • 1/4 inch Screw (M4x6) - (8 pieces) • Window Seal A, B (2 pieces) Type A Type B Type C Type D Type E SHAPE SPEC M8 x 45 M5 x 30 M4 x 16 M4 x 8 M4 x 6 Q'TY 2 4 8 2 8 Frame Guide Lower (2 pieces) DRAIN Seal Sill Bracket (2 pieces) Window Seal A (1 piece) Window Seal B (1 piece) Sash Bracket DRAIN (1 piece) Window kit Frame . NOTE: Use Screw Right side (1 piece) (Type D) only • Step 2 - Prepare Window For Installation 1. Inspect window track, sash and sill to be sure they are strong enough to hold an air conditioner. 2. Measure width between window frame to be sure instant mount wi...

Téléchargez votre

Pour télécharger, entrez 2 chiffres :