|
Facilité d'utilisation
NOTE: The last three digits of the slicer serial number are etched on the Key (Fig. 8) so you can make sure the Carriage Tray stays with its own slicer. Remove the Top Knife Cover by rotating the Latch Knob (Fig. 4) counterclockwise and lifting it free of the guide pins. Remove the Deflector (Fig. 1) from its mount below the slicer knife by rotating downward. Clean both Top Knife Cover and Deflector with warm soapy water in a sink. Rinse with clean water. LATCH KNOB CARRIAGE TRAY / SUPPORT ARM CARRIAGE TRAY KNOB PL-41402-1 GAUGE PLATE KNIFE SHARPENER LOCK LEVER RING GUARD KNIFE PAPER TOWEL GAUGE PLATE PL-41403-1 Fig. 5 Fig. 6 Remove the sharpener by pushing the Lock Lever to the left (Fig. 5). Tilt the right side up, clearing the right guide pin, then lift the sharpener up, clearing the left guide pin. Wipe out any residue remaining inside the sharpener housing and clean the sharpener in a sink. Rinse with fresh water. Clean completely around the Ring Guard by working a moistened, folded paper towel between the Ring Guard and Knife. Insert the towel at the base of the Ring Guard. Manually rotate the knife and the towel will wipe the Ring Guard and the edge of the Gauge Plate as it follows the knife (Fig. 6). Wash and rinse both sides of the knife by wiping outward from the center. Use a mild detergent or sanitizer solution only. Never clean any part of the slicer with steel pads. Do not exceed chemical manufacturer’s recommended concentrations for detergent or sanitizer. Do – 6 – not exceed 200 parts per million concentration of available chlorine. For example, mixing 1 tablespoon (15 ml) of 5.25% sodium hypochlorite bleach with 1 gallon (4.5 litres) of water yields a solution containing 200 ppm of available chlorine. Solution with concentrations greater than 200 ppm will accelerate corrosion of metals. Maximum exposure to sanitation solution varies with temperature and concentration. Rinse with clean water. not exceed 200 parts per million concentration of available chlorine. For example, mixing 1 tablespoon (15 ml) of 5.25% sodium hypochlorite bleach with 1 gallon (4.5 litres) of water yields a solution containing 200 ppm of available chlorine. Solution with concentrations greater than 200 ppm will accelerate corrosion of metals. Maximum exposure to sanitation solution varies with temperature and concentration. Rinse with clean water. Carefully reassemble the Top Knife Cover by putting it in position (three guide pins). Lock by turning the Latch Knob to the left while lowering the Top Knife Cover; then, release the Latch Knob and turn it to the right until snug. Replace the Deflector below the slicer knife: Guide bottom of socket onto mount and rotate upwards. Make sure the digits etched on the Key (Fig. 8) match the last three digits of the slicer serial number. To reinstall the Carriage Tray / Support Arm: Hold it with both hands and lower it so the Key at the bottom of the Support Arm fits into the slot of the Carriage Pivot (Fig. 8). The Ca...
Ce manuel est également adapté pour les modèles :Casseroles - 2812 ML-104959 (927.41 kb)
Casseroles - 2912 ML-104761 (927.41 kb)
Casseroles - 2912 ML-104821 (927.41 kb)
Casseroles - 2912 ML-104964 (927.41 kb)