Évaluations - 3, GPA: 4.3
(
)
)
|
Facilité d'utilisation
Electrical safeguards • The unit must be connected to a supply voltage corresponding to the electrical rating shown on the unit. • Unplug the unit before moving it, or when it is not in use for an extended period of time. • Do not operate with a damaged supply cord or plug. Do not alter the attachment plug. The plug is configured for the appropriate electrical supply. • Do not overload electrical outlets beyond their capacity; fire or electrical shock could result. • The unit is intended for indoor use only. • Never push objects through the cabinet slots. Do not spill liquid of any kind on this product. • Close supervision is required when this product is used near children. Service • Do not attempt to service or repair the pouch laminator yourself. Unplug the unit and contact an authorized GBC service representative for any required repairs. Important: Before operating your new laminator, lift up the exit tray located at the rear of the machine and lock it in place (fig. 1). 4 5 6 7 8 Operation, hot lamination 1 2 3 Connect power cord to appropriate power source. Push the power button to turn the power "ON" (fig. 2). The inside of the laminator will glow red. Using the lamination guideline table here below, select the appropriate temperature setting for the pouch gauge thickness and material you are laminating. • If the laminated item appears to be cloudy, it means that the laminator temperature is not hot enough. Allow the laminator to heat for a few more minutes then run the pouch through again. • If the laminated item is wavy, the TEMPERATURE is too hot. Verify temperature selector is set at the appropriate temperature. • Always allow sufficient time for the laminator to adjust to changes in temperature setting. The inside of the laminator will glow green when the laminator has reached operating temperature. Position the document to be laminated into a GBC laminating pouch, so that the document is aligned to the folded sealed edge and the right and left borders are equal and insert the pouch into the carrier (fig. 3). Insert the carrier straight into the machine, leading with the folded edge (fig. 4). The carrier will automatically exit the rear of the machine. After the carrier has stopped moving, immediately place it on a flat surface to cool for one minute before handling (fig. 5). If you have finished laminating, push the switch to turn "OFF" the machine. 1 4 CARRIER 2 3 5 CARRIER 6 Copy Paper Setting Glossy Paper Setting Photo Paper Setting 2 - 4 4 - 6 7 - 8 4 - 6 6 - 8 9 - 10 3 mil. 5 mil. The inside of the laminator will glow green. Use and laminate your GBC cold pouch. (Pressure sensitive—non-thermal laminating pouch) Connect power cord to appropriate power source. Rotate the temperature dial to the "cold" position (fig. 2). Push the power button to turn the power "ON" (fig. 2). Operation, cold lamination 1 2 3 4 5 Anti-jam feature: Important Information How to use the release lever. 1 2 If carrier jams or is fed improperly, turn off the laminator immediately. Press the release lever down to release the motor from the rollers (fig. 6). Helpful lamination hints 1 Temperature setting Guidelines: When laminating thin paper with light ink coverage, set the temperature dial at the low end of the range. Thick paper and heavy ink coverage require higher settings. Temperature settings will vary due to the finish, chemistry and heat absorption properties of the material being laminated. 2 Before laminating important or unique documents always run a test pouch through the laminator using a similar type document. Warranties Operation of this machine is guaranteed for two years from date of purchase, subject to normal use. Within the guarantee period, GBC will at its own discretion either repair or replace the defective machine free of charge. Defects due to misuse or use for inappropriate purposes are not covered under the guara...
Ce manuel est également adapté pour les modèles :Laminator - H310 (107.39 kb)