Évaluations - 4, GPA: 3.8
(
)
)
|
Facilité d'utilisation
DO NOT OVERTIGHTEN screws. 10. Replace lens over base. Replace lens screw. 11. Replace helmet over lens. Replace helmet screw. FINAL WIRING INSTRUCTIONS Use ONLY the rated voltage (see chart above). All positive wires must be protected by a 1-amp fuse. Higher voltage or failure to make proper wire and fuse connections will void the product warranty. Use crimp type marine-grade connectors with suitable insulation. Protect all connections with suitable materials. 1. Neatly thread wires to the switch, avoiding areas where abrasion or snagging may occur. 2. Use switch (Attwood #14386 or equivalent) that allows two-position ON/OFF/ON operation — one for running lights, and one for anchor lights. Attach wires with crimp-on butt joint connectors. Test lights for proper operation. MAINTENANCE To replace lamp: Remove the helmet and lens (Figure 2). Use small slotted screwdriver to pry old lamp out of terminals. Replace with the proper festoon-base lamp: Attwood #9230 (12-volt), or #910409 (24-volt). Replace lens, helmet, and retaining screws. ATTWOOD LIMITED WARRANTY This product carries the standard Attwood one-year warranty. See Product Catalog or for details. ©2003 Attwood Corporation 1016 N. Monroe Street, Lowell, MI 49331-0260 www.attwoodmarine.com...
Ce manuel est également adapté pour les modèles :équipement pour bateaux - 3831 (452.54 kb)
équipement pour bateaux - 3830 (452.54 kb)
équipement pour bateaux - 3834 (452.54 kb)
équipement pour bateaux - 3835 (452.54 kb)