Évaluations - 5, GPA: 4.6 ( )

Fabricant : Echo Taille : 556.44 kb Nom Fichier : 3f858f4f-0b60-49b5-a6f8-ec4a7a994de4.pdf Langue d'enseignement:

See Service and Adjustments. Throttle Control Lever Fast Slow Stop The throttle control lever controls the speed of the engine. The settings are OX0210 variable between fast and slow. Recoil Starter Handle The recoil starter handle is used to start the engine. Primer Bulb For a cold engine, push the primer bulb three times to add fuel for easier engine OX0040 start. See Starting and Shut Off. Swivel Head Lock The swivel head feature is designed to allow close trimming while walking parallel to fences or walls. • Point the front of the unit to the left if trimming with the left side of the trimmer. • Point the front of the unit to the right if trimming with the right side of the trimmer. To adjust, see Service and Adjustments. WARNING: EXPLOSIVE VAPORS and FLAMMABLE FUEL can result in serious injury or death. Handle fuel with care. ALWAYS use an approved fuel container. No Smoking! No Lighted Materials! No Open Flame! Allow engine to cool before maintenance. Never fill tank when engine is running or is hot from operation. DO NOT overfill tank. Allow about 1/4" (6.35 mm ) of space at the top of the filler neck for fuel expansion. Wipe up any spills and allow vapors to dissipate before starting engine. Use approved (Red) gasoline container. To add fuel to Fuel Tank: 1. Put unit in open or well-ventilated area. 2. Stop engine and allow to cool. 3. Clean Fuel Cap and surrounding area to prevent dust, dirt and debris from entering Fuel Tank. 4. Remove Cap. IMPORTANT: DO NOT use gasohol or gasoline containing alcohol because alcohol will cause internal parts to deteriorate. See Engine Manual for correct type and grade of fuel. 5. Fill fuel tank. (See Specifications for tank capacity.) 6. Replace Fuel Cap and tighten. 7. ALWAYS clean up any spilled fuel. TO STOP IN AN EMERGENCY To stop in an emergency, release control bail. When all moving parts have stopped, push throttle control lever to stop. GB - 9 TO START AND SHUT OFF ENGINE TO START AND SHUT OFF ENGINE 1. Check engine oil level. See Engine Manual. 2. Check fuel level. Starting the Engine 1. Push primer bulb 2 or 3 times for a cold engine. 2. Set throttle control to Fast. 3. Grasp starter handle and pull rope out slowly until it pulls harder. This is the compression stroke. Let rope rewind slowly. Then pull rope with rapid continuous full arm stroke to start engine. Allow rope to rewind slowly. IMPORTANT: DO NOT let starter handle snap against handlebar. 4. Repeat until engine starts. (If engine does not start, refer to Troubleshooting.) Stopping the Engine 1. Release control bail so that trimmer head stops rotation. Wait until rotating parts stop completely before leaving operator’s position. 2. Push throttle control lever to Stop. 3. If leaving unit unattended, disconnect spark plug wire to prevent start-up. TO OPERATE THE TRIMMER CAUTION: Before every use, clean grass and debris from foam debris screen and around muffler. 1. Start the engine. 2. Set throttle control to Fast. 3. Hold the control bail against the handlebar to engage the trimmer head. 4. When trimmer head is rotating at full speed, move unit forward to trim. TO TRAVEL TO ANOTHER WORK AREA When crossing driveways or bare areas, release the control bail to stop trimmer head rotation and push down slightly on the handlebar to lift the trimmer head off the ground. This prevents premature wear of the trimmer head. TRIMMING TIPS • Operating the trimmer in Fast throttle provides the best trimming performance. • In heavy growth, walk slower. • Do not push the trimmer into heavy growth too fast. • Do not trim on extremely steep slopes. Do not trim on slopes when the ground is wet or slippery. If you do not feel comfortable on a slope, do not trim it. • Keep the trimmer clear of dirt and grass build-up. • Install a new trimmer line when line is worn to less than 4 inches (10.2 cm). See Service and Adjustments. TO TRANSPORT UNIT ALWAYS turn engine off when transporting on truck or trailer. Tie unit down securely. Do not tie down by linkages, guards, cables or other parts that may be damaged. GB - 10 MAINTENANCE MAINTENANCE WARNING: AVOID INJURY. Read and understand the entire Safety section before proceeding. Maintenance Schedule Service Performed Intervals (Hours) Each Use 25 50 Check Fasteners • Check Trimmer Lines • Check Control Bail Operation • Check Engine Oil • Clean Debris Screen • Clean Unit • Check Air Cleaner •1 Check Spark Plug • Change Engine Oil •2 •1 Clean Engine Cooling Fins •1 1. More often under extremely dusty or dirty conditions. 2. Change engine oil after first 2 hours of use, then every 25 hours or every season, whichever comes first. SERVICE POSITION 1. Remove the gas cap and place a piece of plastic (a plastic garbage bag works well) over the tank opening. Reinstall the cap. This keeps gasoline from spilling out the tank. 2. Set the unit swivel in the center position. 3. Loosen the two wing nuts on the lower handlebar. 4. Tip the unit up onto its back to rest on the lower handleb...

Téléchargez votre

Pour télécharger, entrez 2 chiffres :