Log:
Évaluations - 1, GPA: 5 ( )

Instructions Flymo, Modèle Samurai 800/1000

Fabricant : Flymo
Taille : 2.1 mb
Nom Fichier : 97e43ee0-f0dd-4a08-90b0-b032366b60d3.pdf
Langue d'enseignement: ruplsvitenesfrdeetslnlhuptskdaficslvltro
Aller à la télécharger



Facilité d'utilisation


Even with a R.C.D. installed 100% safety cannot be guaranteed and safe working practice must be followed at all times. Check your R.C.D. every time you use it. 2. Before use, examine cable for damage, replace it if there are signs of damage or ageing. 3. Do not use the trimmer if the electric cables are damaged or worn. 4. Immediately disconnect from the mains electricity supply if the cable is cut, or the insulation is damaged. Do not touch the electric cable until the electrical supply has been disconnected. Do not repair a cut or damaged cable. Replace it with a new one. 5. Your extension cable must be uncoiled, coiled cables can overheat and reduce the efficiency of your trimmer. 6. Keep the cable clear of the cutting area and obstacles at all times. 7. Do not pull cable around sharp objects. 8. Always switch off at the mains before disconnecting any plug, cable connector or extension cable. 9. Never pull on the cable to disconnect any of the plugs. 10.Switch off, remove plug from mains and examine electric supply cable for damage or ageing before winding cable for storage. Do not repair a damaged cable, replace it with a new one. Use only Flymo replacement cable. 11. Always wind cable carefully, avoiding kinking. 12.Use only on AC mains supply voltage shown on the product rating label. 13. Flymo trimmers are double insulated to EN60335. Under no circumstance should an earth be connected to any part of the trimmer. Cables Use only 1.00mm2 size cable up to 40 metres length maximum. Maximum rating: 1.00mm2 size cable 10 amps 250 volts AC 1. Mains cables and extensions are available from your local Approved Service Centre. 2. Only use extension cables specifically designed for outdoor use. Preparation 1. While using your product always wear substantial footwear and long trousers. 2. Before using the machine and after any impact, check for signs of wear or damage and repair as necessary. 3. Inspect the area to be cut before each use. Remove all objects such as stones, broken glass, nails, wire, string etc, which can be thrown or become entangled in the trimmer head. 4. Check that the cutting head is fitted correctly. Use 1 . Use the trimmer only in daylight or good artificial light. 2. Avoid operating your trimmer in wet grass, where feasible. 3. Take care in wet grass, you may lose your footing. 4. On slopes, be extra careful of your footing and wear non-slip footwear. 5. Do not walk backwards when trimming, you could trip. Walk never run. 6. Keep cutting head below waist level. 7. Never operate the trimmer with damaged guards or without guards in place. 8. Never fit metal cutting elements. 9. Keep hands and feet away from the cutting means at all times and especially when switching on the motor. 10. Never pick up or carry a trimmer by the cable. 11. Do not lean over the trimmer guard - objects may be thrown by the cutting line. 12. Remove the plug from the mains : - before leaving the trimmer unattended for any period; - before clearing a blockage; - before checking, cleaning or working on the appliance; ENGLISH - 1 Safety - if you hit an object. Do not use your trimmer until you are sure that the entire trimmer is in a safe operating condition; - if the trimmer starts to vibrate abnormally. Check immediately. Excessive vibration can cause injury. Maintenance and storage 1. Keep all nuts, bolts and screws tight to be sure the trimmer is in safe working condition. 2. Replace worn or damaged parts for safety. 3. Only use the replacement cutting line specified for this product. 4. Only use replacement parts and accessories recommended by Husqvarna Outdoor Products. 5. To avoid the risk of injury keep fingers and hands clear of the line cutter on the leading edge of the guard. 6. Inspect and maintain the trimmer regularly. Any repairs must be carried out by an authorised repairer. Environmental Information Awareness of the environment must be considered when disposing of ‘end-of-life’ product. If necessary, contact your local authority for disposal information. The symbol yQk on the product or on its packaging indicates that this product may not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. For more detailed information about recycling of this product, please contact your local council office, your household waste disposal service or the shop where you purchased the product. Service Recomendations • Your product is uniquely identified by a silver and black product rating label. • We strongly recommend that your product is serviced at least every twelve months, more often in a professional application. Guarantee and Guar...


Écrivez votre propre critique du dispositif



Texte du message
Votre nom :
Entrez les deux chiffres :
capcha





catégories