Évaluations - 4, GPA: 4.3
(
)
)
|
Facilité d'utilisation
Do not operate whilst people, especially children or pets are in the area. Electrical AVOID ACCIDENTAL STARTING, REMOVE PLUG FROM MAINS AND KEEP FEET AWAY FROM THE SWITCH LEVER WHEN:- CLEANING AROUND THE INSIDE OF THE SAFETY GUARD, REMOVING OR REFITTING SPOOL CAP, MANUALLY FEEDING OR REPLACING NYLON LINE 1. The use of a Residual Current Device (R.C.D.) with a tripping current of not more than 30mA is recom- mended. Even with a R.C.D. installed 100% safety cannot be guaranteed and safe working practice must be followed at all times. Check your R.C.D. every time you use it. 2. Before use, examine cable for damage, replace it if there are signs of damage or ageing. 3. Do not use the product if the electric cables are damaged or worn. 4. Immediately disconnect from the mains electricity supply if the cable is cut, or the insulation is dam- aged. Do not touch the electric cable until the electrical supply has been disconnected. Do not repair a cut or damaged cable. Replace it with a new one. 5. Your extension cable must be uncoiled or un- wound, coiled or wound cables can overheat and reduce the efficiency of your mower. 6. Keep the cable clear of the cutting area and ob- stacles at all times. 7. Do not pull cable around sharp objects. 8. Always switch off at the mains before discon- necting any plug, cable connector or extension cable. 9. Switch off, remove plug from mains and examine electric supply cable for damage or ageing before winding cable for storage. Do not repair a damaged cable, replace it with a new one. Use only Flymo replacement cable. 10. Always wind cable carefully, avoiding kinking. 11. Never carry the product by the cable. 12. Never pull on the cable to disconnect any of the plugs. 13. Use only on AC mains supply voltage shown on the product rating label. 14. Our products are double insulated to EN60335. Under no circumstance should an earth be con- nected to any part of the product. Cables Use only 1.00mm2 size cable up to 40 metres length maximum. Maximum rating: 1.00mm2 size cable 10 amps 250 volts AC 1. Mains cables and extensions are available from your local Husqvarna UK Ltd. Approved Service Centre. 2. Only use extension cables specifically designed for outdoor use. Preparation 1. While using your product always wear substan- tial footwear and long trousers. 2. Before using the machine and after any impact, check for signs of wear or damage and repair as necessary. 3. Inspect the area to be cut before each use. Remove all objects such as stones, broken glass, nails, wire, string etc, which can be thrown or become entangled in the trimmer head. 4. Check that the cutting head, spool and cap are fitted correctly. Use 1. Use the trimmer only in daylight or good artificial light. 2. Avoid operating your trimmer in wet grass, where fea- sible. 3. Take care in wet grass, you may lose your foot- ing. ENGLISH - 1 Safety 4. On slopes, be extra careful of your footing and wear non-slip footwear. 5. Do not walk backwards when trimming, you could trip. Walk, never run. 6. Switch off before pushing the trimmer over surfaces other than grass. 7. Never operate the trimmer with damaged guards or without guards in place. 8. Never fit metal cutting elements. 9. Keep hands and feet away from the cutting means at all times and especially when switching on the motor. 10.Keep cutting head below waist level. 11. Do not lean over the trimmer guard whilst trimming or edging - objects may be thrown by the cutting line. 12.Beware of cut-off pieces of nylon line ejected during use. 13.Never pick up or carry a trimmer by the cable. 14.Remove the plug from the mains: -before leaving the trimmer unattended for any period; - before clearing a blockage; - before checking, cleaning or working on the ap pliance; -if you hit an object. Do not use your trimmer until you are sure that the entire trimmer is in a safe operating condition; -if the trimmer starts to vibrate abnormally. Check immediately. Excessive vibration can cause injury. Maintenance and storage 1. Keep all nuts, bolts and screws tight to be sure the trimmer is in safe working condition. 2. Replace worn or damaged parts for safety. 3. Only use the replacement cutting line specified for this product. 4. Only use replacement parts and accessories recommended by Husqvarna UK Ltd.. 5. After any maintenance in dealing with the cutting line, always return the product to its normal operating position before switching on. 6. Clean unit with a dry cloth. Never use metal objects to clean the unit. 7. Inspect and maintain the trimmer regularly. Any repairs must be carried out by an authorised repairer. 8. Store in a cool dry place and out of reach of children. Do not store outdoors. Environmental Information • Awareness of the environment must be considered when disposing of .end-of-life. product. • If necessary, contact your local authority for disposal information....
Ce manuel est également adapté pour les modèles :Clippers - MT25 (1.23 mb)