Évaluations - 4, GPA: 3.8
(
)
)
|
Facilité d'utilisation
(4) Reset the filter to the fuel tank, and securely tighten the fuel tank cap. (5) Then, continue to operate the engine until it stops. (6) Remove the spark plug, and drip several drops of engine oil through the spark plug hole. (7) Gently pull the starter handle so that engine oil will spread over the engine, and attach the spark plug. (8) During storage, in order for the machine to become uprighting, please keep. (9) Keep the drained fuel in a special container in a well-ventilated shade. 16 Fault location Fault System Observation Cause Engine not starting or with difficulty Warm start problems Engine starts but dies Insufficient performance Ignition system Fuel supply Compression Mechanical fault Fuel supply Several systems may simultaneously be affected Ignition spark O.K. No ignition spark Fuel tank filled No compression when pulled over Starter not engaging Tank filled ignition spark existing Tank filled Engine idling poor Fault in fuel supply or compression system, mechanical defect STOP-switch operated, wiring fault or short circuit, spark plug or connector defective, ignition module faulty Incorrect choke position, carburetor defective, fuel supply line bent or blocked, fuel dirty. Cylinder bottom gasket defective, crankshaft seals damaged, cylinder or piston rings defective or improper sealing of spark plug Broken starter spring, broken parts inside of the engine Carburetor contaminated, have it cleaned Incorrect idling adjustment, carburetor contaminated Fuel tank vent defective, fuel supply line interrupted, cable or STOP-switch faulty Air filter contaminated, carburetor contaminated, muffler clogged, exhaust duct in the cylinder clogged Operating time Item Before operation After lubrication Daily (10h) 30h 50h 200h Shutdown /rest Corres-po nding P Engine oil Inspect/clean 0 9 Replace 0*1 14 Tightening parts (bolt, nut) Inspect 0 16 Fuel tank Clean/inspect 0 . Drain fuel 0*3 16 Throttle lever Check function 0 . Stop switch Check function 0 11 Low-speed rotation Inspect/adjust 0 12 Air cleaner Clean 0 15 Ignition plug Inspect 0 15 Cooling air duct Clean/inspect 0 16 Fuel pipe Inspect 0 16 Replace .*2 . Fuel filter Clean/replace 0 16 Clearance between air intake valve and air discharge valve Adjust .*2 . Oil tube Inspect .*2 . Engine overhaul .*2 . Carburetor Drain fuel 0*3 16 *1 Perform initial replacement after 20h operation. *2 For the 200 operating hour inspection, request Authorized Service Agent or a machine shop. *3 After emptying the fuel tank, continue to run the engine and drain fuel in the carburetor. 17 TROUBLESHOOTING Before making a request for repairs, check a trouble for yourself. If any abnormality is found, control your machine according to the description of this manual. Never tamper or dismount any part contrary to the description. For repairs, contact Authorized Service Agent or local dealership. Remedy Engine does not start Failure to operate primer pump Push 7 to 10 times. Low pulling speed of starter rope Pull st...
Ce manuel est également adapté pour les modèles :Clippers - PS-410 (3.24 mb)
Clippers - PB-250.4 (3.24 mb)
Clippers - PB-500 R (3.24 mb)
Clippers - PS-33 (3.24 mb)