Évaluations - 0, GPA: 0
(
)
)
|
Facilité d'utilisation
If handled properly and according to the instructions in this user manual, the appliance is safe to use based on scientific evidence available today. Charging Charge the appliance fully before you use it for the first time. It takes approximately 10 hours to fully charge the batter y. A fully charged appliance has a cordless trimming time of up to 35 minutes. Note:The appliance does not run from the mains. When the battery is empty, charge it as described below. 1 2 3 Do not charge the appliance for more than 24 Make sure the appliance is switched off (Fig. 1). Insert the appliance plug into theappliance (Fig. 2). , Put the adapter in the wall socket. The green light on the adapter goes on to indicate that the appliance is charging. (Fig. 3) hours. Optimising the lifetime of the battery When the appliance has been charged for the first time, we advise you to use it until the batter y is completely empty. Do not recharge the appliance in between the trimming sessions. Continue to use the appliance until the motor almost stops running during a session. Then recharge the batter y. Follow this procedure at least twice a year. Trimming Always comb the beard and/or moustache with a fine comb before you star t trimming. When you trim for the first time, be careful. Do not move the trimmer too fast. Make smooth and gentle movements. Trimming with beard trimming comb 1 Turn the Precision Zoom Lock ` to the desired hair length setting. (Fig. 4) See the table below for an over view of the hair length settings and the corresponding hair lengths. SettingResultinghairlength1 1.5mm 2 2.5mm 3 4mm 4 5.5mm 5 7.5mm 6 9.5mm 7 12mm 8 15mm 9 19mm The setting appears in the window below the Precision Zoom Lock `. Note:When you trim for the first time, start at the highest setting (9) to familiarise yourself with the appliance. Switch on the appliance. To trim in the most effective way, move the trimmer against the direction of hair growth. Make sure the surface of the comb always stays in contact with the skin (Fig. 5). 4 If a lot of hair has accumulated in the comb, remove the beard trimming comb and blow and/or shake the hair out of the comb.The selected hair length setting does not change when you do this (Fig. 6). Trimming with the unique ‘stubble look’ setting 1 To create a ‘stubble look’, trim with the beard trimming comb set to hair length setting 1 (Fig. 7). Trimming without beard trimming comb 2 3 Use the trimmer without beard trimming comb to trim full beards and single hairs. 1 Pull the comb off the appliance to remove it (Fig. 8). Never pull at the flexible top of the beard trimming comb. Always pull at the bottom part. 2 Switch on the appliance. 3 Make well-controlled movements.Touch the hair lightly with the trimmer (Fig. 9). Cleaning Never use scouring pads, abrasive cleaning agents or aggressive liquids such as alcohol, petrol or acetone to clean the appliance. 1 Make sure the appliance is switched off and disconnected from the mains before you clean it...
Ce manuel est également adapté pour les modèles :Clippers - QT4020/60 (2.42 mb)
Clippers - QT4020/10 (2.42 mb)