Fabricant : Bosch Taille : 1.39 mb Nom Fichier : Langue d'enseignement:

Aller à la télécharger

Self-cleaning surface in the cooking compartment The back panel of the oven is coated with self-cleaning enamel. It cleans itself while the oven is in operation. Sometimes, larger splashes of food may not disappear until the oven has been operated several times. Notes ¦ Never treat the self-cleaning surface with oven cleaner. If oven cleaner accidentally gets onto the rear wall, remove it immediately with a sponge and plenty of water. ¦ Never use abrasive cleaning agents. You will scratch or destroy the highly porous coating. ¦ Never clean the self-cleaning surface with a scouring pad. ¦ Light discolouration of the enamel does not affect self- cleaning. Cleaning the cooking compartment floor, ceiling and side walls Use a dish cloth and hot soapy water or a vinegar solution. It is best to use oven cleaner if there are very heavy deposits of dirt. Only use oven cleaner in a cold oven. Malfunction table Malfunctions often have simple explanations. Please refer to the : Risk of electric shock! malfunction table before calling the after-sales service. Incorrect repairs are dangerous. Repairs may only be carried If a meal does not turn out exactly as you wanted, refer to the out by one of our trained after-sales engineers. Tested for you in our cooking studio section, where you will find plenty of cooking tips and tricks. Malfunction table Problem Possible cause Remedy/information The appliance does not work Faulty circuit breaker Look in the fuse box to make sure that the fuse for the appliance is OK. Plug not plugged in Plug the plug in Power cut Check whether the kitchen light works. Incorrect operation Disconnect the fuse in the fuse box. Reconnect it after approx. 10 seconds. Three zeros are flashing in the dis-Power cut Reset the clock. play. The appliance is not in operation. A The start button was not pressed after the set-Press the start button or switch off the applicooking time appears in the display. ting had been made. ance. The microwave does not switch on. The door was not fully closed. Check whether food remains or foreign material is trapped in the door. Make sure that the sealing surfaces are clean. Check whether the door seal is twisted. The †button has not been pressed. Press the †button. Problem Possible cause Remedy/information It takes longer than before for the The microwave power setting is too low. Select a higher power setting. food to heat up. A larger amount than usual has been placed Double the amount = almost double the time in the appliance. The food was colder than usual. Stir or turn the food during cooking An audible signal sounds. The colon The appliance is in demonstration mode. 1. Press the 2button. in the display flashes. 2. Press and hold the hbutton for three seconds. The demonstration mode is deactivated. Error messages You can take remedial action yourself for some error messages. Error message Possible cause Remedy/Note Error message "Er1" or "Er4" appears The temperature sensor has failed. Call the aftersales service. in the display. Error message "Er11" appears in the The buttons are dirty or the mechanics have Press all buttons several times and, if this display. “Button jammed" jammed. does not help, contact the after-sales service. Error message "Er19" appears in the There is extreme overheating (possibly a fire Do not open the door. Disconnect from the display. inside). Microwave power setting too high. mains or switch off the fuse in the fuse box and allow to cool down. Error message "Er17", "Er18" or Technical malfunction. Call the aftersales service. "E305" appears in the text display. Replacing the oven light bulb It is possible to replace the oven light. Heat-resistant 240 V, 25 W halogen bulbs can be obtained from after-sales service or a specialist retailer. : Risk of electric shock! Never replace the oven light when the appliance is switched on. Pull out the mains plug or switch off the appliance at the circuit breaker in the fuse box. Note: Always remove the new halogen bulb from the packaging using a dry cloth. This increases the service life of the bulb. Method Note: You must remove the whole appliance in order to replace the cooking compartment light. Follow the installation instructions. 1. Unplug the appliance from the mains or switch off the circuit breaker in the fuse box. 2. Open the appliance door. Undo the securing screws on the right and left-hand side of the oven. Follow the installation instructions. 3. Carefully lift out the appliance. 4. Undo the screw from the light cover on the outer left-hand side wall and remove the cover. (Fig. A) Pull out the halogen light. (Fig. B). 5. Insert the new halogen bulb (Fig. C) .. .. .. 6. Screw the lamp cover in place. Reassemble the appliance in the reverse order. 7. Switch the circuit breaker in the fuse box back on or plug in the mains plug. Replacing the glass cover If the glass cover in the oven is damaged, it must be replaced. You can obtain covers from the after-sales service. Please supply your ap...

Ce manuel est également adapté pour les modèles :
fours à micro-ondes - HB84E562/36 (1.39 mb)
fours à micro-ondes - HB84E562/37 (1.39 mb)
fours à micro-ondes - HB84E562/39 (1.39 mb)

Téléchargez votre

Pour télécharger, entrez 2 chiffres :