Évaluations - 2, GPA: 4 ( )

Fabricant : Hobart Taille : 467.94 kb Nom Fichier : Langue d'enseignement:

During the MIX operation, the mixing arm rotates in reverse direction from MIX-GRIND operation and the grinder worm does not rotate. Continuous mixing occurs along with grinding in the MIX-GRIND operation. Mixing of uncut or unground meat is not recommended. Grinding Procedure First Grind . . . Fill the hopper and close the hopper guard. Overfilling will bend the hopper guard and may cause the interlock to open the electrical circuit. Push the MIX-GRIND Button to start grinding. Press the STOP Button to stop grinding. Second Grind . . . Fill the hopper and close the hopper guard. Press the MIX Button. After desired mixing, press the STOP Button. Then, press the MIX-GRIND Button to start grinding; press the STOP Button to stop grinding; or activate and use the optional accessory Foot Switch. – 7 – CLEANING WARNING: DISCONNECT THE ELECTRICAL POWER SUPPLY BEFORE CLEANING OR SERVICING THIS MACHINE. In any cleaning operation after disconnecting the electrical power supply, seal the receptacle to prevent entrance of moisture. To make this seal on Hobart supplied receptacles and pendant connectors, place the cover cap into position and turn the screw type sealing ring clockwise. Remove the following components when cleaning: Mixing arm, adjusting ring, knife, plate, worm and cylinder (also the side feed hopper plug, when used). The method for removing these components has already been described (refer to Grinder Attachment, page 7). The mixing arm seal (Fig. 3) at the drive end of the mixing arm should be removed by hand for cleaning. Grasp the outer flange or use a dull screwdriver tip and pull the seal out. Also, an accessory tool is available to assist in removal and reassembly of the mixing arm seal. The machine can be washed down with hot water or steam as is customary in meat processing operations. When using detergents and sanitizers, follow the manufacturer's instructions. Rinse with clear water. Allow to air dry. After cleaning the machine, reassemble the mixing arm seal, mixing arm, and bushing retainer. After cleaning, a light coat of food grade mineral oil is recommended for the cylinder, adjusting ring, knife, plate, and worm — before reassembly. MAINTENANCE WARNING: DISCONNECT THE ELECTRICAL POWER SUPPLY BEFORE CLEANING OR SERVICING THIS MACHINE. LUBRICATION Both motor bearings are pre-lubricated and sealed. No further lubrication is required. Gear Case To check the oil level in the gear case, turn off the machine, wait at least one minute (for all oil to drain down) and check the oil level sight gauge (Fig. 1). Maintain the oil at the proper level as described on page 3. Every six months, remove the drain plug (Fig. 1) and drain the gear case. Refill with approximately 84 fluidounces of Mobil DTE HM oil. Chain Drive Reservoir Replenish the chain drive reservoir (Fig. 1) as necessary with MPO-30 Multi-Purpose Oil. SERVICE Contact your local Hobart Service Office for any repairs or adjustments needed on this equipment. FORM 33737 (10-96) – 8 – PRINTED IN U.S.A. ...

Téléchargez votre

Pour télécharger, entrez 2 chiffres :