Évaluations - 3, GPA: 3.7 ( )

Fabricant : Campbell Hausfeld Taille : 1.54 mb Nom Fichier : Langue d'enseignement:

Add engine oil (supplied) to engine. Refer to engine manual supplied by engine manufacturer for procedure. Do not overfill. Use of a funnel is recommended. NOTE: There will be a slight amount of oil in the engine from factory testing. NOTE: The pump was filled with oil at the factory. There is no need to add oil at this time, see the Maintenance section of this manual to perform maintenance on this pump. 7 — ENG D22885 TO ASSEMBLE ACCESSORIES PANEL REMOVE SHIPPING PLUG (PCV2021) (PCH2627, PCH3030) REMOVE SHIPPING PLUG (PCV2021) (PCH2627, PCH3030) 3.Place grooves in accessories panel assembly onto screws and slide panel assembly into place. 4.Place screws (removed earlier) into the top holes and secure accessories panel assembly to handles. Do not overtighten. The handle MUST be THE assembled to the frame PUMP IS in order to safely assemble the acces- SHIPPED FROM THE FACTOsories panel. RY WITH OIL IN IT AND A RED SHIPPING PLUG TO PREVENT 1. Remove top screws on handle assembly. ANY OIL FROM LEAKING OUT OF THE 2. Loosen bottom screws on handle assembly. PUMP DURING SHIPMENT. ATTACHED TO THE SHIPPING PLUG IS A PLASTIC BAG (SEE THE FOLLOWING PHOTO) WHICH CONTAINS THE DIPSTICK/OIL PLUG THE SHIPPING PLUG MUST BE REMOVED AND THE DIPSTICK/OIL PLUG INSTALLED BEFORE THE PRESSURE WASHER IS OPERATED. Loosen 1. Using a 17 mm wrench, remove shipping plug from pump by turning it counterclockwise. Discard plug. Accessories Panel Screws 2. Remove dipstick/oil plug from plastic bag. Before installing dipstick/oil plug into pump, check the pump oil level. See Pump paragraph in Maintenance section of this manual. 8 — ENG D22885 OPERATION BASIC ELEMENTS OF A PRESSURE WASHER High Pressure Pump: Increases the pressure of the water supply. Engine: Drives the high pressure pump. High Pressure Hose: Carries the pressurized water from the pump to the gun and wand. Spray Gun: Connects with wand to control water flow rate, direction, and pressure. Wand: Multi-Reg wand (PCV2021): Adjusts the pressure setting from low to high as well as a variable adjustment between a narrow jet stream and 40° fan spray. Quick Connect Turret Wand (PCH2425, PCH2627, PCH3030, PCH3540HR): Conveniently stores Q.C. nozzles at wand end for quick and easy adjustment to 5 spray patterns: 0, 15, 25, 40 and soap/chemical Chemical Hose: Allows cleaners or cleaning solvents to be mixed with the pressurized water stream. See How To Siphon Chemicals/Cleaning Solvents in Operation section of this manual. EZ Start Valve: Allows the starter cord on the engine to be pulled without causing a pressure build up in the hose. BASIC ELEMENTS OF ENGINE Choke Control (if equipped): Opens and closes the choke valve in carburetor. Primer Button (if equipped): Primes carburetor with fuel. Throttle Control Lever: Controls engine speed. Starter Grip: Pulling starter grip operates recoil starter to crank engine. Fuel Valve Lever (if equipped): Opens and closes connection between fuel tank and carburetor. E...

Téléchargez votre

Pour télécharger, entrez 2 chiffres :