Évaluations - , GPA: ( )

Instructions Craftsman, Modèle D27927-034-0

Fabricant : Craftsman
Taille : 1.23 mb
Nom Fichier : 91d100e6-481a-4020-9679-4f103d226beb.pdf

Langue d'enseignement:

Le document est chargé, s'il vous plaît patienter

Téléchargez votre Fermer

Le document est chargé, s'il vous plaît patienter

Téléchargez votre Fermer

8. Reconnect spray wand to gun and turn on water supply. 9. Start pressure washer and place spray wand into high pressure setting to test. HOW TO CLEAN THE WATER INLET FILTER This screen filter should be checked periodically and cleaned if necessary. 1. Remove filter by grasping end and removing it from water inlet of pump as shown. 2. Clean filter by flushing it with water on both sides. 3. Re-insert filter into water inlet of pump. NOTE: Cone side faces out. NOTE: Do not operate pressure washer without filter properly installed. Filter Screen D27927 16- ENG STORAGE ENGINE Consult the Engine Owners Manual for the manufacturer's recommendations for storage. PUMP 1. Drain all water from high pressure hose, coil it, and store it in cradle of the pressure washer handle. 2. Drain all water from spray gun and spray wand by holding spray gun in a vertical position with nozzle end pointing down and squeezing trigger. Store in gun/hose holder. 3. Store chemical hose, high pressure hose, spray gun, and spray wand so they are protected from damage, such as being run over. It is recommended that you follow these steps to protect the internal seals of the pressure washer when STORING THE UNIT FOR MORE THAN 30 DAYS AND/OR WHEN FREEZING TEMPERATURES ARE EXPECTED. *RV antifreeze needs to be run through the pump as outlined in the steps below. 4. Obtain a funnel, six ounces of *RV antifreeze, and approximately 36 inches of garden hose with a male hose connector attached to one end. Use only RV antifreeze. Any other antifreeze is corrosive and can damage pump. 5. Disconnect spark plug wire. 6. Connect 36 inch length of hose to water inlet of pump. 7. Add *RV antifreeze to hose as shown. 8. Pull engine starter rope slowly several times until antifreeze comes out of high pressure hose connection of pump. 9. Remove short hose from water inlet of pump. 10. Reconnect spark plug wire. *Windshield washer fluid may also be used 17- ENG D27927 TROUBLE SHOOTING GUIDE PROBLEM CAUSE CORRECTION Engine will not start (see Engine Manual for further engine troubleshooting) No fuel. Low oil Pressure builds up after two pulls on the recoil starter or after initial Add Fuel. Add required amount of oil. Squeeze gun trigger to relieve pressure. use. Spark plug wire not attached. Engine ON/OFF switch in OFF position Choke lever in the “Choke” position on a “hot” engine or an engine that has been exposed to thermal heat for a long period of time. Fuel valve closed Choke lever in the “No Choke” position. Attach spark plug wire. Place engine ON/OFF switch in on position. Move choke to the “No Choke” position. Move the fuel valve lever to the “Open” position. Move choke to the “Choke” position. No or low Spray wand not in high pressure. See How to Use Spray Wand pressure paragraph in the Operation(initial use) Low water supply. Leak at high pressure hose fitting. Nozzle obstructed. Water filter screen clogged. Defective E-Z start valve. Air in hose. Choke lever in the “Choke” position. Th...