This may be useful for determining if a Host is reachable. H| The tab has no matching menu in the Webpage Administration Interface of Section 1. Figure 2-17: 4-1 Installing the Software | Evert Log | Session Statutes | PCoiP Process«* Pin.; | Determine i a host is reachable across the network Destination II interval [Ï ] seconds Packet Stre [32_| bytes Packets Sent 0 Received 0 i Start Stop (_ Close Ping Settings • IP Address or FQDN to ping • Interval between ping packets • Size of ping packet Packets • Number of ping packets sent • Number of ping packets received Window The window allows an administrator to access the Version tab containing information about the device. Figure 2-18: lrrfon | Vtew the hardware and firmware version information MAC Address 00-15-B7-9C-S3M Unique identfier 00-1547-9C-83-64-clent-2 Sertai Ntmber Frmware Part Number FW010003 Hardware Version Firmware Version 0-20 Firmware BuM ID v120 Firmware BuW Date Mar 20 2008 18:40:40 PColP Processor Revision 0.0 Bootloader version O.Q Bootloader BukS ID Bootloader BuW Date 1 |_ Ciose Installing the Software 4-1 VPD Information Vital Product Data (VPD) is information provisioned by the factory to uniquely identify each Portal or Host. • Portal unique • Portal unique identifier • Portal unique serial number • Part number of PCoIP firmware • Portal hardware version number Firmware Information The reflects the current PCoIP firmware details. • Version of the current PCoIP firmware • Revision code of the current PCoIP firmware • Build date of the current PCoIP firmware The Revision field reports the PCoIP Processor Revision code. TERA1x00 Revision A silicon is denoted by 0.0 and TERA1x00 Revision B silicon is denoted by 1.0. Bootloader Information The Bootloader information reflects the current PCoIP bootloader details. • Version of the current PCoIP bootloader • Revision code of the current PCoIP bootloader • Build date of the current PCoIP bootloader Window The window allows the user to access window tabs that define the mouse and keyboard settings and the PCoIP image quality. The tabs in the User Settings menu are: • • • Tab The tab allows a user to change the mouse cursor speed settings for the OSD and RDP sessions. pH • The OSD mouse cursor speed setting does not affect the mouse cursor settings when a PCoIP session is active unless the Local Keyboard Host Driver function is being used (see PCoIP Host Software User Guide for more information). • The tab has no corresponding menu in the Webpage Administration Interface of Section 1. 4-1 Installing the Software Figure 2-19: • The field allows the Portal mouse cursor speed to be configured. The can also be configured via the PCoIP Host Software. For more information on using the PCoIP Host Software, refer to the PCoIP Host Software User Guide for more information. Tab The tab allows a user to change the keyboard repeat settings for the OSD and RDP sessions. pH • The keyboard settings do not affect the keyboard settings when a PCoIP session is active unless the Local Keyboard Host Driver function is being used (see PCoIP Host Software User Guide for more information). • The tab has no corresponding menu in the Webpage Administration Interface of Section 1. Figure 2-20: • The field allows a user to configure the Portal keyboard repeat delay. • The field allows a user to configure the Portal keyboard repeat rate. Installing the Software 4-1 • The field allows a user to test the chosen keyboard settings. The allows a user to change the image settings on the PCoIP system. PH • The Image parameters can also be configured using the Webpage Administration Interface. Figure 2-21: • The slider allows a user to make compromises between image quality and frame rate when network bandwidth is limited. Some usage cases may require lower-quality images at a higher frame rate, while in other cases higher-quality images at a lower frame rate may be preferred. In environments where network bandwidth is constrained...
)
