Évaluations - 0, GPA: 0
(
)
)
|
Facilité d'utilisation
This appliance is intended for domestic use in private households and for a domestic environment. The appliance is fitted with interference suppression in accordance with EU Directive 2004/108/EC. The refrigeration circuit has been checked for leak tightness. This appliance corresponds to the relevant safety requirements for electrical appliances (EN 60335-2-24). en Directions for disposal x Disposing of packaging The packaging protects your appliance from damage during transport. All the materials used are environmentally friendly and can be recycled. Please help by Disposing of the packaging in an environmentally-responsible manner. You can obtain information about current disposal methods from your specialist dealer or local council. x Disposing of your old appliance Old appliances are not useless waste. Valuable raw materials can be recovered through environmentally responsible disposal. This appliance is marked in accordance with European directive 2002/96/EC regarding old electric and electronic appliances (waste electrical and electronic equipment -WEEE). The directive provides a framework for the collection and recycling of old appliances, which is valid across the EU. ! Warning For worn-out appliances: 1. Unplug the mains plug. 2. Cut the power cord and remove it along with the mains plug. 3. Do not remove the shelves and containers. Leaving them intact makes it more difficult for children to climb in. 4. Never let children play with a disused appliance. Risk of asphyxiation! Refrigerators contain refrigerant as well as gases in the insulation material. Refrigerant and gases must be disposed of properly. Do not damage the refrigerant circuit pipes before disposing of them properly. Scope of delivery After unpacking the appliance, check all parts for transport damage. If you wish to make a complaint, please contact the dealer from whom you purchased the appliance or our after-sales service. The scope of delivery includes the following parts: • Free-standing appliance • Features (vary depending on the model) • Instructions for use • After-sales service booklet • Guarantee slip • Information on energy consumption and noises • Bag of assembly materials. Installing the appliance Transport For transport, smooth-running rollers are attached to the appliance. Figure $ ! Warning If required, secure the appliance against rolling away. Removing the transport locks Figure # (not on all models) Remove the four transport locks that are attached between the chest lid and the appliance. Place two of these transport locks on the holders provided for them on the rear of the appliance. This will maintain the minimum distance from the wall, meaning that the chest lid can be opened properly and that adequate ventilation is ensured. This means that the appliance will achieve its stated energy consumption. Location The ideal installation location is a dry, well-ventilated room. The installation location should not be subject to direct sunlight or be near a heat source such as a cooker, heating element, etc. If setting up the appliance next to a heat source is unavoidable, use a suitable insulating plate or observe the following minimum distances from the heat source: • 3 cm from an electric or gas cooker. • 30 cm from oil or solid fuel cookers. If the appliance is placed against the wall, there must be a minimum distance of 70 mm to the back panel and to the side panels. Floor surface The floor at the installation location must not buckle and you may have to reinforce the floor. Use a spirit level to align the appliance. Level out any unevenness in the ground using support spacers. en Note the room temperature and ventilation Ambient temperature The appliance is designed for a certain climate class. Depending on the climate class, the appliance can be operated at the following ambient temperatures. The climate class is specified on the rating plate, figure !/10. Climate class Permissible ambient temperature SN +10 °C to 32 °C N +16 °C to 32 °C ST +16 °C to 38 °C T +16 °C to 43 °C Note! The appliance can function within the ambient temperature limits of the specified climate class. If an appliance in the SN climate class is operated at lower ambient temperatures, damage to the appliance can be excluded up to a temperature of +5 °C. Ventilation Figure * The air on the appliance's back panel and side panels heats up. The heated air must be able to escape unimpeded. Otherwise, the refrigerating unit has to work harder, which increases the appliance's power consumption. Therefore: You must never cover or block the ventilation openings! en Connecting the appliance After setting up the appliance, wait for at least 1 hour before starting the appliance up. The oil contained in the compressor may have been displaced into the refrigeration system during transport. Before starting the appliance up for the first time, clean its interior (see section "Cleaning the appliance"). Electrical connection The socket must be near to the appli...
Ce manuel est également adapté pour les modèles :Congélateurs - DF6034W2VV/02 (758.02 kb)