Évaluations - 0, GPA: 0
(
)
)
|
Facilité d'utilisation
23 3139 115 21171 12/11/01, 5:29 PM Clock/Timer English 2 Press CD, TUNER or TAPE to select the desired source. . Before setting the timer, make sure the music source has been prepared. CD – Load the disc(s).To star t from a specific track, make a programme (refer to “CD Operation - Programming the disc tracks”). TUNER – tune to the desired radio station. TAPE – load the prerecorded tape into tape deck 2. 3 Press a or a on the system repeatedly to set the hour for the timer to star t. 4 Press i or e on the system repeatedly to set the minute for the timer to star t. 5 Press CLOCK•TIMER to store the star t time. . "TIMER ON" will be displayed and followed by the set timer "XX:XX" and then the selected source. . TIMER will remain on the display. . At the preset time, the selected source will play. To exit without storing the setting . Press Con the system. Notes: – If CD is the selected source and it is not available when the preset time is reached,Tuner will be selected automatically. – During timer setting, if no button is pressed within 90 seconds, the system will exit timer setting mode automatically. To deactivate the TIMER . Press TIMER ON/OFF on the remote control. . The display will show "CANCEL" and TIMER will disappear from the display. To activate the TIMER . Press TIMER ON/OFF on the remote control. . The last set timer information will be shown for a few seconds and TIMER will appear on the display. Sleep Timer Setting The sleep timer enables the system to switch to Standby mode automatically within a preset amount of time. 1 Press SLEEP on the remote control repeatedly to select a preset amount of time. . The selections are as follows (time in minutes): 15 ™ 30 ™ 45 ™ 60 ™ OFF ™ 15 … . "SLEEP XX" or "OFF" will be displayed. "XX" is the time in minutes. 2 When you reach the desired length of time, stop pressing the SLEEP button. . SLEEP will appear on the display, except for "OFF" mode. . The Sleep Timer is now set. Before the system switches to standby mode, a countdown of 10 seconds will be displayed. "SLEEP 10" ™ "SLEEP 9".... ™ "SLEEP 1" ™ "SLEEP" While SLEEP mode is activated To check the remaining length of time . Press SLEEP once. To change the preset sleep timer . Press SLEEP twice. . The display will show the remaining time followed by the sequence of sleep timer options. To deactivate the Sleep Timer . Press SLEEP repeatedly until "OFF" is displayed, or press the STANDBY ON button. 24 3139 115 21171 pg 001-027/C788/21-Eng 24 12/11/01, 5:29 PM Specifications AMPLIFIER Output power ........................................................................ .......................... 3500 W PMPO / 2 x 140 W RMS(1) Signal-to-noise ratio .......................... . 75 dBA (IEC) Frequency response ......... 50 – 20000 Hz, ± 3 dB Input sensitivity AUX In / CDR/DVD In .................... 500 mV / 1V Output Speakers .................................................................... . 6 . Headphones ...................................... 32 . – 1000 . Line Out ...................... 500 mV ±2dB, > 22000 . Digital Out .................................... IEC 958, 44.1 kHz (1) (6 ., 1 kHz, 10% THD) CD PLAYER Number of programmable tracks ......................... 40 Frequency response .......................... 20 – 20000 Hz Signal-to-noise ratio ....................................... . 76 dBA Channel separation .......................... . 79 dB (1 kHz) Total harmonic distor tion ............ < 0.02% (1 kHz) TUNER FM wave range ................................... 87.5 – 108 MHz MW wave range (9 kHz) ............. 531 – 1602 kHz MW wave range (10 kHz) ........... 530 – 1700 kHz Tuning grid ............................................................ 9/10 kHz Number of presets ........................................................ 40 Antenna FM ....................................................................... 75 . wire AM .............................................................. Loop antenna TAPE PLAYER Frequency response Normal tape (type I) ...... 80 – 10000 Hz (8 dB) Signal-to-noise ratio Normal tape (type I) ................................. . 48 dBA Wow and flutter ......................................... . 0.4% DIN SPEAKERS Front left/right System ..................... 3-way; Bass reflex system with front firing wOOx Impedance ........................................................................ 6 . wOOx ............... 1 x 6.5" front firing wOOx driver Woofer ...................................................................... 1 x 6.5" Tweeter .......................................................................... 1 x 2" Polydome Tweeter ................................................... 1 x 1" Dimensions (w x h x d) . 240 x 350 x 310 (mm) Weight ................................................................ 4.2 kg each GENERAL Material/finish ................................... Polystyrene/Metal AC Power For Version /21-21M .. 110 – 127 / 220 – 240 V; ................