Évaluations - 1, GPA: 4
(
)
)
|
Photos et spécifications Sony CMT-EX1 |
Facilité d'utilisation
General There is no sound. • Press VOL +. • Make sure the headphones are not connected. • Check the speaker connections. There is severe hum or noise. • A TV or VCR is placed too close to the system. Move the system away from the TV or VCR. “0:00” (or “12:00AM”) flashes in the display. • A power failure occurred. Set the clock and timer settings again. The timer does not function. • Set the clock correctly. The remote does not function. • There is an obstacle between the remote and the system. • The remote is not pointing in the direction of the system’s sensor. • The batteries have run down. Replace the batteries. • Do not place the system in locations where it is near an electric inverter system. CD Player The CD cannot be read. • The CD was not placed in the disc tray properly. Place a CD vertically in the tray. The CD will not eject. • The CD has tape, stickers, or paste on it. The CD will not play. • The CD is dirty. Clean the CD with a cleaning cloth. • The face of the CD is scratched. Exchange the CD. • The CD is facing the wrong way. • Moisture condensation has built up. Remove the CD and leave the system turned on for about 2 hours until the moisture evaporates. Play does not start from the first track. • The player is in program or shuffle mode. Press CD PLAY MODE repeatedly until “SHUF” and “PGM” disappear. “- OVER -” is displayed. • By pressing M, the last track on the disc has been exceeded. Press and hold (or press repeatedly) m or . to return to a track where playback can begin. Tuner Severe hum or noise (“TUNED” or “STEREO” flashes in the display). • Remove the FM antenna from the rear panel and place the antenna outside the cabinet. Adjust the antenna. • The signal strength is too weak. Connect an external antenna. • Make sure the antenna is connected properly. • The AM antenna wire is detached from the stand. A stereo FM program is not received in stereo. • Press STEREO/MONO so “STEREO” appears. If other problems not described above occur, reset the system as follows: 1 Unplug the AC power cord. 2 Hold down ?/1, then plug the AC power cord into the wall outlet again. The system is reset to the factory settings. All the settings you made, such as the preset stations, clock, and timer are cleared. You should set them again. Additional Information Specifications Amplifier section For the U.S. model AUDIO POWER SPECIFICATIONS POWER OUTPUT AND TOTAL HARMONIC DISTORTION: With 4 ohm loads both channels driven, from 70 – 20,000 Hz; rated 10 watts per channel minimum RMS power, with no more than 0.9% total harmonic distortion from 250 milliwatts to rated output. Canadian model: Continuous RMS power output (Reference) 15 + 15 watts (4 ohms at 1 kHz, 10% THD) European model: DIN power output (Rated) 12 + 12 watts (4 ohms at 1 kHz, DIN) Continuous RMS power output (Reference) 15 + 15 watts (4 ohms at 1 kHz, 10% THD) Music power output (Reference) 15 + 15 watts Other models: DIN power output (Rated) 12 + 12 watts (4 ohms at 1 kHz, DIN, 240 V) 12 + 12 watts (4 ohms at 1 kHz, DIN, 220 V) Continuous RMS power output (Reference) 15 + 15 watts (4 ohms at 1 kHz, 10% THD, 240 V) 15 + 15 watts (4 ohms at 1 kHz, 10% THD, 220 V) Inputs TAPE IN: voltage 250 mV, impedance 47 kilohms Outputs TAPE OUT: voltage 250 mV, impedance 1 kilohms CD OUT: Optical PHONES (stereo mini jack): accepts headphones of 8 ohms or more CD player section System Compact disc and digital audio system Laser Semiconductor laser (.=780 nm) Emission duration: continuous Laser output Max. 44.6 .W* * This output is the value measured at a distance of 200 mm from the objective lens surface on the Optical Pick-up Block with 7 mm aperture. Frequency response 20 Hz – 20,000 Hz Tuner section FM stereo, FM/AM superheterodyne tuner FM tuner section Tuning range North American model: 87.5 – 108.0 MHz (100 kHz step) Other models: 87.5 – 108.0 MHz (50 kHz step) Antenna FM wire antenna Antenna terminals 75 ohms unbalanced Intermediate frequency 10.7 MHz AM tuner section Tuning range North American model: 531 – 1,710 kHz (with the interval set at 9 kHz) 530 – 1,710 kHz (with the interval set at 10 kHz) European model: 531 – 1,602 kHz (with the interval set at 9 kHz) Other models: 531 – 1,602 kHz (with the interval set at 9 kHz) 530 – 1,710 kHz (with the interval set at 10 kHz) Antenna AM loop antenna External antenna terminals Intermediate frequency 450 kHz Speaker Speaker system 2-way, bass-reflex type Speaker units Woofer: 9 cm (3 5/8 in) dia., cone type Tweeter: 2 cm (13/16 in) dia., balanced drive Impedance 4 ohms Dimensions 130 . 216 . 183 mm (5 1/8 . 8 5/8 . 7 1/4 in) (w/h/d, incl. projecting parts and controls) Mass Approx 1.8 kg (3 lb 15 oz.) net per speaker General Power requirements North American model: 120 V AC, 60 Hz European model: 230 V AC, 50/60 Hz Other models: 110 – 240 V AC, 50/60 Hz Power consumption 40 W Dimensions 170 . 217 . 200 mm (6 3/4 . 8 5/8 . 7 7/8 in) (w/h/d, incl. projecting parts and controls) Mass Approx. 3.0 kg (6 lb 10 oz...