Évaluations - 4, GPA: 4.3
(
)
)
|
Photos et spécifications Sony CMT-EH25 |
Facilité d'utilisation
.a disc recorded with a complicated tree structure. .a disc recorded in multisession mode. .a disc that has not been finalized (a disc to which data can be added). .a disc that has many folders. Tape deck The sound exhibits excessive wow or flutter or dropout. .Clean the capstans and pinch rollers. Also, clean and demagnetize the tape heads. See “Precautions” for details. USB device Are you using a supported USB device? .If you connect an unsupported USB device, the following problems may occur. See “Playable USB devices with this system” (page 31) for the supported device types. .The USB device is not recognized. .File or folder names are not displayed on this system. .Playback is not possible. .The sound skips. .There is noise. .A distorted sound is output. “OVER CURRENT”appears. .A problem has been detected with the level of electrical current from the (USB) port .. Turn off the system and remove the USB device from the (USB) port .. Make sure there is no problem with the USB device. If this display pattern persists, contact your nearest Sony dealer. There is no sound. .The USB device is not connected correctly. Turn off the system , then reconnect the USB device and check if “USB” appears. There is noise, skipping, or distorted sound. .Turn off the system, then reconnect the USB device. .The music data itself contains noise, or the sound is distorted. Noise may have been introduced when creating music data due to the conditions of the computer. Create the music data again. .The bit rate used when encoding the files was low. Send files encoded with higher bit rates to the USB device. The USB device cannot be connected into the (USB) port .. .The USB device is being connected backwards. Connect the USB device in the correct orientation. Others Continued . GB “READING”is displayed for an extended time, or it takes a long time before playback starts. .The reading process can take a long time in the following cases. .There are many folders or files on the USB device. . The file structure is extremely complex. .The memory capacity is excessive. .The internal memory is fragmented. Thus, we recommend following these guidelines. .Total folders on USB device: 100 or less .Total files per folder: 100 or less Erroneous display .Send the music data to the USB device again, as the data stored in the USB device may have been corrupted. .The character codes that can be displayed by this system are numbers and alphabet only. Other characters are not displayed correctly. The USB device is not recognized. .Turn off the system and reconnect the USB device, then turn on the system. .Connect the supported USB device (page 31). .The USB device does not work properly. Refer to the USB device operation manual for how to deal with this problem. If the problem persists, contact your nearest Sony dealer. Play does not start. .Turn off the system and reconnect the USB device, then turn on the system. .Connect the supported USB device (page 31). .Press . (or USB .. on the unit) . to start play. Files cannot be played back. .The MP3 file does not have the extension “.mp3”. .The data is not stored in MP3 format. .USB storage device formatted with file systems other than FAT16 or FAT32 are unsupported.* .If you use partitioned USB storage device, only files on the first partition can be played. .Playback is possible up to 8 levels. .The number of folders has exceeded 999. .The number of files has exceeded 999. .Files that are encrypted or protected by passwords, etc. cannot be played back. * This system supports FAT16 and FAT32, but some USB storage device may not support all of these FAT. For details, see the operation manual of each USB storage device or contact the manufacturer. GB Tuner Tuner .Connect the antenna properly. .Find a location and an orientation that provide good reception, and then set up the antenna again. .Keep the antennas away from the speaker cords, the power cord and the USB cable to avoid picking up noise. .Turn off nearby electrical equipment. Several radio stations can be heard at the same time. .Find a location and an orientation that provide good reception, and then set up the antenna again. .Bundle the antenna cables using commercially available cord clips, for example, and adjust the cable lengths. To change the AM tuning interval The AM tuning interval is factory-preset to 9 kHz (or 10 kHz, for some areas; this function is not available on the European and Russian models). Use buttons on the unit to change the AM tuning interval. 1 Tune in any AM station, and then turn off the system. 2 Press ./.. to turn off the system. 3 Press DISPLAY . to display the clock. 4 While the clock is displayed, hold down TUNING + . and then press ./.. to turn on the system. All the AM preset stations are erased. To reset the interval to the factory preset, repeat the procedure. To reset the system to factory settings If the system still does not operate properly, reset the system to factory settings. Use buttons on the unit...
Ce manuel est également adapté pour les modèles :Stéréo - CMT-EH26 (804.51 kb)