Évaluations - 3, GPA: 4
(
)
)
|
Facilité d'utilisation
Connecting optional AVcomponents and outdoor antennas Connecting a turntable To enhance your system, you can connect a turntable. Refer to the instructions of each component. Make sure to match the colour of the plugs and the connectors. To the audio output of a turn table. To listen to the sound of a turntable Press PHONO. “Phono” appears in the display. Tip You can record the turntable sound. continuedE LBT-G1/LBT-G1300. 3-859-546-53. EN Connecting optional AV AM antenna components and outdoor Connect a 6- to 15- meter (20- to 50- feet) antennas (continued) insulated wire to the AM antenna terminal. Connecting outdoor antennas Connect the outdoor antenna to improve the reception. FM antenna Connect the optional FM outdoor antenna. You can also use the TV antenna instead. ANTENNA AM FM750HM y75-ohm coaxial cable (not supplied) Ground wire (not supplied) Screw clamp Leave the supplied AM loop antenna connected. ANTENNA AM FM750HM yGround wire (not supplied) Insulated wire (not supplied) Screw clamp Important Ground the external antenna from yterminal against lightning. To prevent a gas explosion, do not connect the ground wire to a gas pipe. LBT-G1/LBT-G1300. 3-859-546-53. EN Basic Operations Basic Operations Playing a CD You can play up to three CDs continuously. p DISC 1–3 1 0/)±. VOLUME 2 1 Press ¤and place a CD on the disc tray. With the label side up. When you play a single CD, place it on the inner circle of the tray. To place the third disc, press DISC SKIP to rotate the disc tray. 2 Press aP. The disc tray closes and play starts from the CD loaded on the tray whose button is lit green. Track number 1 2 3 PRESET EQ DISC FLAT ROCK POPS JAZZ Playing timeDisc tray number To Do this Stop play Press p. Pause Press aP. Press again to resume play. Select a track Press )± or 0 (or +or =on the remote). Find a point in Press and hold down )± a track or 0 during play and release it at the desired point. Select a CD Press DISC 1 – 3 or DISC SKIP. Remove or Press ¤. exchange the CD Adjust the Turn VOLUME (or press VOL volume + or – on the remote). Tips • Pressing aPwhen the power is off automatically turns the power on and starts CD playback if there is a CD on the tray (One Touch Play). • You can switch from another source to the CD player and start playing a CD just by pressing aP(Automatic Source Selection). • When the disc tray is selected or the CD loaded on the tray is playing, the DISC 1 – 3 button for the tray is lit green. Basic Operations LBT-G1/LBT-G1300. 3-859-546-53. EN Recording a CD Use a TYPE I (normal) tape. 6 4 2,3 51 1 Press p6and insert a blank tape into deck A. With the side you want to record on facing forward 2 Press ¤and insert a CD on the disc tray. With the label side up. When you play a single CD, place it on the inner circle of the tray. 3 Press ¤. The disc tray closes. 4 Press one of the DISC 1 – 3 buttons to select a CD. 5 Press ron deck A. Recording starts. 6 Press aP. CD play starts. To stop recording Press p6on deck A and pon the CD player. Note You cannot listen to other sources while recording. LBT-G1/LBT-G1300. 3-859-546-53. EN Listening to the radio –– Preset Tuning Firstly preset radio stations in the tuner’s memory (see page 6). POWER VOLUME 2 0/)± 1 1 Press TUNER/BAND repeatedly until the band you want appears. Each time you press the button, the band changes as follows: FM.AM 2 Press PRESET + or – to tune in the desired preset station. To listen to non-preset radio stations Press )±or 0repeatedly to tune in the desired station. Tips • Pressing TUNER/BAND when the power is off automatically turns the power on and tunes to the last received station (One Touch Play). • You can switch from another source to the tuner just by pressing TUNER/BAND (Automatic Source Selection). • To improve broadcast reception, reorient the supplied antennas. Basic Operations PRESET TUNED PRESET EQ FLAT ROCK POPS JAZZ MHz Preset number Frequency To Turn off the radio Adjust the volume Do this Press POWER. Turn VOLUME (or press VOL + or – on the remote). 11 LBT-G1/LBT-G1300. 3-859-546-53. EN Recording from the radio You can record the radio program on a tape by calling up a preset station. Use a TYPE I (normal) tape. To stop recording Press p6on deck A. Tips • To record non-preset stations, press )±or 0repeatedly to tune in the desired station. • If noise is heard while recording an AM radio, move the AM antenna to reduce the noise. 4 312 1 Press TUNER/BAND to select the band you want. 2 Press PRESET + or – to tune in a preset station. 3 Press p6and insert a blank tape into deck A. With the side you want to record on facing forward 4 Press r. Recording starts. LBT-G1/LBT-G1300. 3-859-546-53. EN Playing a tape Use a TYPE I (normal) tape. 2 VOLUME 0 ) 1 P 3 1 Press p6and insert a recorded tape in deck A or B. With the side you want to play facing forward 2 Press TAPE. “TAPE” appears in the display. 3 Press a. The tape starts playing.* * The deck stops automatically when the playback of the tape...
Ce manuel est également adapté pour les modèles :Stéréo - LBT-G1 (548.23 kb)