Évaluations - 3, GPA: 3.7
(
)
)
|
Par ce dispositif a également d'autres instructions :
Facilité d'utilisation
5 > 5 X 5 N 5 m 5 x 5 5 6 wa 7 w; 8 ql 9 qk q; qj qa qh qs qg qd qf 6GB Getting Started Hooking up the system Perform the following procedure 1 to 5 to hook up your system using the supplied cords and accessories. FM antenna AM loop antenna Front speaker (Right) * MHC-GX40 only 1 Connect the front speakers. Connect the speaker cords to the SPEAKER jacks as shown below. Insert only the stripped portion Getting Started Sub woofer speaker* Front speaker (Left) 2 Connect the sub woofer speaker. (MHC-GX40 only) Connect the speaker cords to the SUB WOOFER OUT jack and SUB WOOFER CONTROL jack as shown below. Red/Solid (3) R+ L + – SUB WOOFER OUT jack Black/Stripe (#) SUB WOOFER CONTROL jack continued 7GB Hooking up the system (continued) 3 Connect the FM/AM antennas. Set up the AM loop antenna, then connect it. Jack type A Extend the FM lead antenna AM loop antenna horizontally FM75 AM Jack type B Extend the FM lead antenna horizontally AM loop antenna AM FM75COAXIAL 4 For models with a voltage selector, set VOLTAGE SELECTOR to the local power line voltage. Depending on the model, the VOLTAGE SELECTOR may differ. 230 - 240V 220V 120V* * Saudi Arabian model: 120 – 127 V 5 Connect the power cord to a wall outlet. The demonstration appears in the display. When you press ?/1, the system turns on and the demonstration automatically ends. If the supplied adapter on the plug does not fit your wall outlet, detach it from the plug (only for models equipped with an adapter). To connect optional components See page 24. To attach the front speaker pads Attach the supplied front speaker pads to the bottom of the speakers to stabilize the speakers and prevent them from slipping. Note Keep the speaker cords away from the antennas to prevent noise. 8GB Placing the sub woofer (MHC-GX40 only) Since the human ear cannot detect the direction and position where the bass sound being reproduced by a woofer (below 150 Hz) comes from, you can place the woofer wherever you like in your room. To obtain a better bass reproduction, we recommend you to place the woofer on a solid floor where the resonance is unlikely to occur. Notes • Always place the woofer vertically, keeping a few centimeters from away the wall. • If the woofer is placed in the center of a room, the bass could be extremely weakened. This is due to the influence of the standing wave of the room. If this happened, move the woofer away from the center of a room or eliminate the cause of the standing wave, by placing a bookshelf on the wall, etc. When carrying this system Perform the following procedure to protect the CD mechanism. 1 Make sure that all discs are removed from the system. 2 Press ?/1 to turn off the system. 3 Unplug the power cord. Getting StartedInserting two R6 (size AA) batteries into the remote EeeE Tip With normal use, the batteries should last for about six months. When the remote no longer operates the system, replace both batteries with new ones. Note If you do not use the remote for a long period of time, remove the batteries to avoid possible damage from battery leakage. 9GB Setting the clock Setting the clock 1 Press ?/1 to turn on the system. 2 Press CLOCK/TIMER SET on the remote. 3 Press . or > on the remote repeatedly to set the hour. 4 Press ENTER on the remote. The minute indication flashes. 5 Press . or > on the remote repeatedly to set the minute. 6 Press ENTER on the remote. The clock starts working. To adjust the clock 1 Press CLOCK/TIMER SET on the remote. 2 Press . or > on the remote to select “CLOCK SET”, then press ENTER on the remote. 3 Do the same procedures as step 3 to 6 above. Note The clock settings are canceled when you disconnect the power cord or if a power failure occurs. CD Loading a CD 1 Press Z OPEN/CLOSE. The disc tray opens. 2 Place a CD with the label side up on the disc tray. To insert additional discs, press DISC SKIP/EX-CHANGE to rotate the disc tray. 3 Press Z OPEN/CLOSE to close the disc tray. 10GB Playing a CD Playing a CD —Normal Play/Shuffle Play/Repeat Play This system lets you play the CD in different play modes. Disc tray number Disc presence Track number Playing time indicator 1 Press CD. 2 Press PLAY MODE on the remote repeatedly until the mode you want appears in the display. Select To play ALL DISCS All CDs in the disc tray (Normal Play) continuously. 1DISC The CD you have selected (Normal Play) in original order. ALL DISCS The tracks on all CDs in SHUF random order. (Shuffle Play) 1DISC SHUF The tracks on the CD you (Shuffle Play) have selected in random order. PGM (Program The tracks on all CDs in the Play) order you want them to be played (see “Programing CD tracks” on page 12). 3 Press H (or N on the remote). Other Operations To Stop play Pause Select a track Find a point in a track Select a CD in stop mode Do this Press x. Press X. Press again to resume play. During play or pause, press > or .. During play, press and hold M or m. Release it when you find the desired point. Press DISC 1 – 3 or DISC SKIP/ ...
Ce manuel est également adapté pour les modèles :Stéréo - MHC-GX20 (266.34 kb)
Stéréo - MHC-GX40 (266.34 kb)
Stéréo - MHC-RG22 (266.34 kb)
Stéréo - MHC-RG33 (266.34 kb)