Évaluations - 3, GPA: 4
(
)
)
|
Facilité d'utilisation
Unauthorized substitutions may result in fire, electric shock, or other hazards. 20. Safety Check - Upon completion of any service or repairs to this product, ask the service technician to perform safety checks to determine that the product is in proper operating condition. 21. Wall or ceiling Mounting - The product should be mounted to a wall or ceiling only as recommended by the manufacturer. 22. Heat - The product should be situated away from heat sources such as radiators. Heat registers, stoves, or other products (including amplifiers) that produce heat. WARNING: Changes or modifications to this unit not expressly approved by the party responsible for compliance couldvoid the user’s authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residentialinstallation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used inaccordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful intereference to radio or television reception, which can be determined by turning the equipment off and on , the user is encouraged to try to correctthe interference by one or more of the following measures: -Reorient or relocate the receiving antenna. -Increase the separation between the equipment and receiver. -Connect the equipment into an circuit different from that to which the receiver is connected. -Consult the dealer or an experienced radio TV technician for help. WARNING: TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. DO NOT REMOVE COVER. PILOT LAMPS SOLDERED IN PLACE. NO USER SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. The exclamation point within an equilateral triangle is intended to alert user to the presence of important operating and maintenance (servicing) instruction in the literature accompanying the appliance. RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION The lighting flash with arrowhead symbol, within an equilateral triangle, is intended to alert user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute risk of electric shock to persons. CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER - SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. CAUTION For Compact Disc Units Only: INVISBLE LASER RADIATION WHEN OPEN AND INTERLOCK FAILED OR DEFEATED. AVOID DIRECT EXPORSURE TO LASER BEAM. • Marking plate was located on bottom enclosure Specification Power Supply : AC 120V ~ 60Hz Power Consumption : 12W Three Speed : 33 1/3, 45, 78 RPM Speaker : 3” Dynamic type x 2 * DESIGN AND SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE. General 7 Troubleshooting The unit does not operate. 1 The AC power cord is not connected to a power outlet. 2 The unit is not turned on : rotate the VOLUME knob from the OFF position TURNTABLE No sound is coming from unit. 1 The white protective needle cover was not removed. 2 The volume is not turned up. Tone arm will not move. 1 Black tie-wrap was not removed from underneath tone arm 2 Tone arm hold down clip was not released. Turntable Operation Turntable Operation Turn the unit on by switching the VOLUME ON/OFF SWITCH(9) to the ON position. 1 Set the speed control switch to the appropriate speed for your record, (33 1/3, 45 or 78 RPM). Place the record on the turntable. 2 Lift the tone arm from its rest and place it gently on the beginning of the record. 3 Adjust volume level to the desired listening level. 4 At the end of the record, the tone arm will automatically return to its rest and the record will stop spinning. 5 Manually move the tone arm over the record and gently place at the beginning of the desired track. Re-adjust the VOLUME control. 6 At the end of the record, the tone arm will automatically return to its arm rest. The red power light will remain on until the unit is turned off. Welcome Table of Contents Turntable Operation Getting Started Control Locators....................... 4 Unpacking the Turntable ......... 5 Power Source ......................... 5 Turntable Operation Turntable Operation ................ 6 Accessory: ADAPTER FOR 45RPM ....... 6 General Troubleshooting Guide ............. 7 Warranty ................................... 8 Thank you for purchasing the Crosley Turntable (CR-48). Before operating this unit, please read this manual thoroughly and retain it for future reference. TO PLAY THE 45RPM RECORD, PLACE THE ADAPTER (1) ON THE SPINDLE. Accessory: ADAPTER FOR 45RPM About This Manual Instructions in this manual describe the control functions of ...