. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 1.1 Audio Features . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 1.2 User Interface . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 2 UNPACKING . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 3 AC POWER REQUIREMENTS . . . . . .

When switched into bridged-mono mode, the amplifier it shall deliver at least 370 watts into a 16 ohm load, and 550 watts RMS into an 8 ohm load. The amplifier shall be immune to damage from shorted, open, or mismatched loads. The amplifier shall have a gain of 29 dB +/- .2dB per channel and an input sensitivity of 1.3 Volts +/-2% for full rated output. Frequency response shall be 20Hz to 20kHz +/- .2dB. It shall be stable into any load, including pure capacitors and inductors. Hum and noise sha

When switched into bridged-mono mode, the amplifier it shall deliver at least 600 watts into a 16 ohm load, and 950 watts RMS into an 8 ohm load. The amplifier shall be immune to damage from shorted, open, or mismatched loads. The amplifier shall have a gain of 29 dB +/- .2dB per channel and an input sensitivity of 1.7 Volts +/-2% for full rated output. Frequency response shall be 20Hz to 20kHz +/- .2dB. It shall be stable into any load, including pure capacitors and inductors. Hum and noise sha

When switched into bridged-mono mode, the amplifier it shall deliver at least 2400 watts into an 8 ohm load. The amplifier shall be immune to damage from shorted, open, or mismatched loads. The amplifier shall have a gain of 38 dB per channel and an input sensitivity of 1 Volt RMS for full rated output. Frequency response shall be 20Hz to 20kHz +/- .2dB. It shall be stable into any load, including pure capacitors and inductors. Hum and noise shall be at least 105dB below full output and total ha

An 45 watts RMS per channel into 8 ohm loads and 60 watts RMS per channel into 4 input jack on the front panel shall be provided for connection of stereo head- ohms. When switched into Bridged-Mono mode, the amplifier shall deliver a total phones. A separate attenuator control for each channel shall also be located on the of 120 watts RMS into 8 ohms. The amplifier shall be immune to damage from front panel. There shall be status L.E.D.’s for each channel on the front panel of shorted, open, or