Log:
Évaluations - 3, GPA: 5 ( )

Instructions Gemini, Modèle UHF-216M

Fabricant : Gemini
Taille : 4.67 mb
Nom Fichier :
Langue d'enseignement: enesfrde
Aller à la télécharger



Facilité d'utilisation


5. Set the channel selector pins (7) on both the transmitter and receiver to the desired frequency as indicated on the included Frequency Chart. 6. Adjust the volume using the level control (4) on the front panel. Note: Effective range between the transmitter and receiver is up to 250 feet. The UHF-216 dual channel UHF series wireless system is two separate single channel transmitters of different frequencies transmitting to one unit that houses both frequency receivers. There is also individual level control for each channel. Two different versions are available and operate on different ranges of UHF frequencies between either 682.35 MHz to 697.1 MHz (US version) and 854.1 MHz to 864.7 MHz (EUROPE version). THE MODELS AVAILABLE ARE: UHF-216M - Which comes equipped with (2) hand held microphone transmitters. UHF-216HL -Which comes equipped with (2) belt pack transmitters and (2) Headset/ lavalier combos. UHF-216 DUAL CHANNEL RECEIVER OPERATION: 1. Remove all packing materials. Save the box and packing materials to transport the unit and in case the unit ever requires service. 2. Plug the AC/DC adaptor into the rear of the receiver (6) and an appropriate AC Outlet. Push the Power On (2) button to turn the unit on. The power indicator will be illuminated. 3. Extend the two antennas fully vertical and point them towards the direction the performer(s) will be speaking from. 4. Insert the 1/4” cable into the jack labeled AUDIO OUT (5) on the rear of the receiver and connect the other end of the cable to your amp, effects or mixer jack. 5. Set the channel selector pins (7) on both the transmitter and receiver to the desired frequency as indicated on the included Frequency Chart. 6. Adjust the volume using the level control on the front panel. Note: Effective range between the transmitter and receiver is up to 250 feet. HAND HELD TRANSMITTER OPERATION 1. Slide the battery cavity (9) to open. Insert two (2) AA batteries into the battery cavity (9) according to the polarity indication marked on the battery housing. 2. Set the channel selector pins (7) on both the transmitter and receiver to the desired frequency as indicated on the included Frequency Chart. 3. Close the battery cavity (9). 4. Push the power switch (8) to the ON position. The BATT indicator (10) should flash once briefly as you turn on the mic indicating that the mic has sufficient power. If the BATT stays on, it indicates that the battery has insufficient power and should be changed. If the BATT does not light at all and the mic does not work, it indicates the battery is dead and you should change the battery. The microphone can be muted by setting the switch (8) to the mute position. If the microphone is not going to be used for any length of time, push the power switch (8) to OFF and remove the battery. Do not switch the mic on and off rapidly, because you wont get a true indication from the BATT indicator. HEADSET/LAVALIER COMBO AND TRANSMITTER OPERATION 1. Slide the battery cavity (9)...

Ce manuel est également adapté pour les modèles :
Instruments de musique - UHF-116M (4.67 mb)
Instruments de musique - UHF-116HL (4.67 mb)
Instruments de musique - UHF-116M (4.67 mb)
Instruments de musique - UHF-216HL (4.67 mb)

Écrivez votre propre critique du dispositif



Texte du message
Votre nom :
Entrez les deux chiffres :
capcha





catégories