Fabricant : Roland
Taille : 251.97 kb
Nom Fichier :
|
Facilité d'utilisation
The chorus/vibrato indicator light should either blink on and off or remain on. • If the chorus/vibrato indicator light is blinking on and off, push the effect/normal changeover switch so that the chorus/vibrato indicator light remains on. • When the chorus/vibrato indicator light remains constantly on, the effect/normal switch is in the normal position, and the sound produced should be normal. When using an instrument, set the chorus intensity knob towards the left to produce a shallow chorus effect. When using a microphone, set the knob towards the right to produce a deeper, more intense sound. By adjusting the chorus intensity knob, a clear, clean sound is produced. • Depending on the instrument used, the input sensitivity changeover switch may be set in either the "high" or "low" position. • Adjust the level control knob so that when using an instrument or microphone at the maximum desired volume the peak level indicator light glows slightly. • If the peak level indicator light does not glow even when both instrument volume control and level control are turned up high, turn the input sensitivity changeover switch to the "high" position. On the other hand, if the peak level indicator lamp glows brightly even at a low volume, turn the input sensitivity switch to the "low" position. Depending on the instrument or microphone in use, it's advisable to try both the "high" and the "low" positions to determine which position produces the better sound. Then, push the effect/normal changeover switch again so that the chorus/vibrato indicator light blinks on and off and the chorus/ vibrato effect can be heard. • Next, push the chorus/vibrato changeover switch and check the chorus/vibrato indicator light. When the chorus/vibrato indicator light blinks rapidly, the vibrato effect is produced. When the vibrato rate knob is turned to the right, the chorus/vibrato indicator light should blink more rapidly. • When the chorus/vibrato indicator light blinks slowly, the chorus effect is produced. When the chorus intensity knob is turned to the right, the chorus/vibrato indicator light should blink more rapidly. (Note) * If adjustment of the chorus intensity knob has no effect on the blinking speed of the chorus/ vibrato indicator light, the chorus/ vibrato changeover switch is in the vibrato position, and thus the vibrato effect is being produced. If adjustment of the vibrato rate knob has no effect on the blinking speed of the chorus/vibrato indi cator light, the chorus/vibrato changeover switch is in the chorus position, and thus the chorus effect is being produced. • BOSS CE-1 CONTROL PANEL L. 2-channel output jack (can also be used monaurally) Input jack Input sensitivity changeover switch U Level control Peak level indicator £ Normal/Effect changeover switch Chorus intensity • peak level Chorus GEnsemble • Vibrato depth control Vibrato rate control Power cord Power switch • Chorus/Vibrato indicator • Chorus/Vibrato changeover switch Power consumption: 3W Input sensitivity: 80mV/10mV Output level: 200mV S/N ratio: 60dB (Over 75dB when used with noise killer) Controls: Power switch, Input sensitivity Controls: Level control, Chorus intensity Vibrato depth, Vibrato rate Switches: Normal/Effect, Chorus/Vibrato Indicators: Peak level, Chorus/Vibrato/Normal Jacks: 1 Input, 2 Outputs Semi-conductors: 4 IC's, 14 Transistors, 3 FET's, 19 Diodes Dimensions: 260mm(W) x 180mm(D) x 64mm(H) 10.2 x 7.1 x 2.5 inch Weight: 1.8kg or 3.96lbs. Specifications and design are subject to change without notice. [Шпо1апсГ RUS10068 UPC RUS10...