Évaluations - 4, GPA: 4
(
)
)
|
Par ce dispositif a également d'autres instructions :
Facilité d'utilisation
3. After aligning the neck, tighten the neck screw to secure it. Neck Screw 4. Moisten the end of the reed in your mouth (or in some water). Assembly Assembly 5. Attach the reed onto the mouthpiece. First, place the reed so that the tip of the mouthpiece is seen over the end of the reed then tighten the ligature screws (two screws) to secure the reed. Reed Ligature Screws 6.Place the strap around your neck then hook the strap onto the strap ring on the instru ment. 7. While holding the instrument, adjust the mouthpiece position and strap length. . Tuning the Instrument Tuning is accomplished by adjusting the position of the mouthpiece on the neck. Since air temperature or the temperature of the instrument will have an effect on tuning, the instrument should be warmed up beforehand by blowing into it. Play a tuning note — • If the pitch is high, pull the mouthpiece slightly off of the neck. • If the pitch is low, push the mouthpiece a little further onto the neck. When the pitch When the pitch is low is high Instrument Maintenance ¦ Instrument Maintenance After Playing After playing the instrument, use the following procedures to remove moisture and dirt from the inside of the instrument. . Remove the reed, then use a cleaning swab (sold separately) to clean the inside of the mouthpiece. The cleaning swab is also used to clean the inside of the instrument’s neck and body. * To prevent damage to the end of the mouthpiece, do not pull the swab all the way through the mouthpiece. * Always keep the cleaning swab clean and dry. . When the pads are wet, place a cleaning paper (sold separately) between the pad and the tone hole and press the pads lightly to completely remove the moisture. . On baritone saxophones, remove moisture using the water keys. . Use a polishing cloth to wipe the instrument’s surface. * When wiping be careful not to apply excessive force on the keys or damage the pads. * Take care not to let the polishing cloth get caught on the pin springs, etc. . Since the tonehole on the octave key is small and becomes easily clogged, use a tonehole cleaner (sold separately) to clean the hole periodically. Instrument Maintenance Instrument Maintenance ¦ Once or Twice a Month Maintenance . Apply a small amount of key oil (sold separately) to the mechanism then move the keys to allow the oil to spread evenly. * Do not apply too much oil. * Completely remove any oil on key surfaces. . Remove dirt from the side surfaces of keys and key posts. Use a small piece of gauze to wipe the surfaces taking care not to place any excessive pressure on the keys. * Make sure that the pin springs, key cork, etc., are not effected when wiping the instrument. Key Post . Use a tone hole cleaner (sold separately) to remove fine dirt or dust from between the keys. * Be careful not to damage the pads. ¦ Cleaning the Neck (Once Every Six Months) The neck should be cleaned once about every six months. 1. Make a lukewarm soap solution mixing brass soap (sold separately) w...
Ce manuel est également adapté pour les modèles :Instruments de musique - YAS-275 (1.95 mb)
Instruments de musique - YSS-475II (1.95 mb)
Instruments de musique - YSS-675 (1.95 mb)
Instruments de musique - YSS-82Z (1.95 mb)