Évaluations - 2, GPA: 3.5
(
)
)
|
Facilité d'utilisation
Spikes located in the legs rubber the drum key bolt. Those in the frame can be extended to the preferred length by rotating the bolts clockwise. u Adjusting Leg Position The position of the legs (footboard) can be adjusted by loosening bolts A and B, shown in the Leg diagram on the right. After the position has been determined, firmly tighten bolts A and B. Footboard (example: HS1100) i Adjust the Footboard Angle The angle adjuster can be used to increase or decrease the amount of footboard angle by raising or lowering the adjuster. With a drum key, loosen the two bolts on either side of the angle adjuster then slide the angle adjuster higher or lower as needed. After the angle has been determined, firmly tighten two bolts with a drum key. Bolt Angle Adjuster o Heel A removable rubber the rubber, reveals a strip of Velcro™ that, provides better grip when the stand is used on carpeted If the Velcro does not provide sufficient grip, use the rubber. !0 The Supplied Soft Case and To protect the hi-hat stand's finish from scratches, etc., werecommend that it be placed in the supplied soft case when transporting. Also, please wrap the upper pipe in the supplied sheet. !1 A protective sheet A protective sheet is applied to the HS1100 to protect the finish. Protect Sheet Note) Moving parts require occasional lubrication for smooth operation. Also, over tightening of the nylon clutch inside the base assembly’s pipe holder may result in damage. Please use caution. Rubber Washer Metal Plate Fixing Nut Cymbal Support Plate Knurled Head Bolt w Hi-Hat Clutch (LC-930) The top hi-hat cymbal is fixed and held in place between the two felts of the hi-hat clutch. (Procedure) 1) Loosen the drum key bolt q on the clutch nut and remove the clutch nut from the clutch bolt. 2) Remove the lower felt and place the cymbal between the upper felt and the lower removed felt. 3) Firmly tighten the clutch nut onto the clutch bolt. Next, tighten the drum key bolt q to lock the clutch nut. Since the drum key bolt q can be locked with a minimum of force, be sure not to over tighten which may cause damage to the bolt. 4) The lock nut adjusts the amount of pressure used to hold the cymbal in place. Loosen the drum key bolt w and raise or lower the lock nut to adjust the position. After the position has been determined, tighten the drum key bolt w to lock the lock nut in place. The drum key bolt w can be locked with a minimum of force so be sure not to over tighten which may cause damage to the bolt. • HS1100 • HS1000 • HS950 Footboard Spikes Heel Hi-Hat Clutch Hi-Hat Shaft Fixing Nut Memory Clamp Knurled Head Bolt Cymbal Support Plate Base Assembly Pipe Holder Adjustment Dial Indicator Bolt A Bolt B Angle Adjuster Printed in Japan Hi-Hat Clutch Hi-Hat Shaft Fixing Nut Spikes Memory Clamp Knurled Head Bolt Cymbal Support Plate Base Assembly Pipe Holder Heel Footboard Adjustment Dial Indicator Bolt A Bolt B Angle Adjuster Hi-Hat Clutch Hi-Hat Shaft Fixing Nut Spikes Memory Clamp Knurl...
Ce manuel est également adapté pour les modèles :Instruments de musique - CHH930 (702.63 kb)
Instruments de musique - HS1200 (702.63 kb)
Instruments de musique - HS1200D (702.63 kb)
Instruments de musique - HS650A (702.63 kb)