Log:
Évaluations - 0, GPA: 0 ( )

Instructions Yamaha, Modèle ATTITUDE LTDII

Fabricant : Yamaha
Taille : 452.78 kb
Nom Fichier :
Langue d'enseignement: en
Aller à la télécharger



Par ce dispositif a également d'autres instructions :

Facilité d'utilisation


2 TUNING MACHINE TENSION ADJUSTMENT ..................... 3 SETTING THE STRING ACTION ........................................ 4 INTONATION ADJUSTMENT .............................................. 5 PICKUP HEIGHT ADJUSTMENT ....................................... 6 TRUSS ROD ADJUSTMENT .............................................. 6 CORRECT USE AND HANDLING OF BATTERIES ............... 7 Safety Precautions .............................................................. 8 CARE AND MAINTENANCE * When connecting or disconnecting cables, turn off the amplifier and other equipment or reduce the volume. Congratulations on your choice of the Yamaha electric bass. * After playing, wipe the entire guitar down, including strings, With reasonable care, your Yamaha with a good polishing cloth. This will remove corrosive skin oils and acids, and protect the plating, finish, and strings. electric bass will age gracefully and provide many years of superlative musi- * Avoid exposing the guitar to direct sunlight and extremes of cal service. heat and humidity. 2 TUNING MACHINE TENSION ADJUSTMENT TUNING MACHINE TENSION ADJUSTMENT Loosen Tighten 3 Tighten Loosen Clockwise rotation tightens the machine. The tuning machines should be adjusted to the extent that they are firm, but can turn smoothly. This adjustment is normally unnecessary, and excessive tightening can lead to premature tuning machine wear. Loosen Tighten SETTING THE STRING ACTION SETTING THE STRING ACTION Height adjustment Set too high and the instrument is hard to play. Too low results in fret noise. Adjust so that the space between the string and the last fret measures as follows: Individual height adjustments for each string are provided in the form of two set screws on each saddle. Clockwise rotation raises saddle height and counter-clockwise lowers the saddle. 4-string bass — 1st 2nd 3rd 4th — STRING 5-string bass — 1st 2nd 3rd 4th 5th 6-string bass TUNING HEIGHT 1st High C 2.6 mm 2nd G 2.7 mm 3rd D 2.8 mm 4th A 2.9 mm 5th E 3.0 mm 6th Low B 3.1 mm NOTE: Be sure to perform any necessary adjustments to the truss rod before performing the following adjustments. 4 Saddle INTONATION ADJUSTMENT INTONATION ADJUSTMENT isters, this adjustment is needed. Check each string in the following way: To check intonation, compare the harmonic tone (12th fret) to the fretted tone (12th fret). Because the 12th fret is the midway point between the nut and the bridge, a harmonic tone one octave higher than the fretted tone can be generated. This is done by barely touching the string directly above the 12th fret (left hand) and simultaneously plucking the same string (right hand). If the fretted tone is exactly the same pitch as the harmonic tone, no adjustments to the bridge saddles are necessary. However, if the fretted tone is higher in pitch (sharp) or lower in pitch (flat) than the harmonic tone, apply the appropriate adjustment as shown below. Repeat the same procedure for each string. If the fretted note is pi...

Ce manuel est également adapté pour les modèles :
Instruments de musique - BB2025X (452.78 kb)
Instruments de musique - BB414X (452.78 kb)
Instruments de musique - BB614 (452.78 kb)
Instruments de musique - BB615 (452.78 kb)

Écrivez votre propre critique du dispositif



Texte du message
Votre nom :
Entrez les deux chiffres :
capcha





catégories