Évaluations - 4, GPA: 3.5
(
)
)
|
Facilité d'utilisation
2. Please visit our website at and register your warranty at the “Register Your Warranty Here” text, or complete the Warranty Registration Card and return it to the factory. DESCRIPTION FRONT PANEL NOTE: Descriptions for Channels 1 - 8 are identical. TRIM: Adjusts the sensitivity of the XLR Microphone Inputs. LEVEL: Adjusts the level of signal in the channel from off to +20 dB of gain. TONE:Cuts the signal up to 12 dB, below 200 Hz when turned clockwise, or above 6 when turned counter-clockwise. MASTER LEVEL: Adjusts the Main Output signal level. pwr: LED indicating power is applied to the RM82. Power Switch: Applies power to the unit. Please ensure the power cable a properly grounded AC outlet. REAR PANEL MAIN OUTPUT: XLR balanced jack containing the PRE-FADE OUTPUT: RCA jack for connection to another device such as a recorder. AUX INPUT: RCA jack which connects directly connected to another RM81 Pre-Fade Output PHANTOM POWER SWITCHES: 8 individual phantom power to the indicated channel’s condenser microphones. The Phantom RM82 is shipped from the factory. CHANNEL INPUTS 1 - 8: 1/The eight 1/4” jacks come as line inputs and mixed with the XLR jacks. reconfigured as either Direct CONNECTION 1. MICROPHONE AND MAIN OUTPUT CONNECTION Connect microphones to the XLR Inputs as shown here. If the microphones are condenser type, and require phantom power - remember to switch on (down) the corresponding Phantom Power switch. Connect the Output to the next device in your signal chain. 2. CONNECTING TWO RM82 UNITS TOGETHER Using a single RCA cable, connect from the Pre-Fader Output of the “Slave” unit to the Aux Bus input of the “Master” unit. This “Master” unit’s Master Level control will now adjust the overall level of both units. 3. CHANNEL DIRECT OUTPUT For each channel you wish to have Direct Output access, you must first configure that channel’s 1/4” Input as a Direct Output. Follow the instructions shown on the back page. Connect a 1/4” unbalanced Tip-Sleeve cable to the channel’s 1/4” jack and to the next device you want the signal to. Note, the channel’s signal will still be present at the RM82 Main 4. CHANNEL INSERT For each channel you wish to have the ability to insert into, you must first configure that channel’s 1/4” Input as an INSERT. Follow the instructions shown on the back page. Connect a 1/4” Tip-Ring-Sleeve INSERT cable into the channel’s 1/4” jack, and to the processor or other device you want the A NOTE ABOUT ROLLS MICROPHONE The Rolls servo-balanced Microphone preamps. Among these are rejection ratio) than transistor input lines, and very at high gains, but preamps have ...
Ce manuel est également adapté pour les modèles :Instruments de musique - RM82 (156.39 kb)