Évaluations - 3, GPA: 3.7
(
)
)
|
Facilité d'utilisation
Remove the battery pack and disconnect the AC adaptor, then connect them again. If the problem persists, contact Panasonic Technical Support. The battery pack or charging circuit may be defective. The green indicator blinks*1 In high temperature mode, the battery is discharging to the level that corresponds to an 80%*2 charge for normal temperature mode. ( “Battery Power”) Do not remove the battery pack while the battery indicator is blinking green. If you remove it, the power will be turned off forcibly. *1 Only for the main battery pack. *2 In high temperature mode, the level that corresponds to an 80% charge for normal temperature mode is displayed as [100%]. The orange indicator blinks Battery cannot be recharged temporarily because the internal temperature of the battery pack is outside of the acceptable temperature range for recharging. Once the allowable range requirement is satisfied, charging begins automatically. Your computer can be used normally in this state. Touch Pad / Touchscreen The cursor cannot be controlled properly If you are using an external mouse, ensure that the external mouse has been connected correctly. Restart the computer by using the keyboard. (Press , U , and select [Restart] with R ) If the computer does not respond to keyboard commands, read “No response” ( page 29). Unable to input using the touch pad Has the Setup Utility been used to set [Touch Pad] to [Enable]? When external mouse drivers are installed (e.g., IntelliMouse), the touch pad may not be used. Has the touch pad driver been properly installed? Unable to point correctly with the stylus included with the computerAs a result of the physical characteristics of the touchscreen, sometimes the position of the stylus does not match the position of the cursor on the screen. This is not a malfunction. Perform [Calibration]. ( page 14) Reference Manual The Reference Manual is Is Adobe Reader installed? not displayed If you have uninstalled Adobe Reader, install using the following procedures. 1 Log on to Windows with the administrator authority. 2 Select [start] - [Run], input [c:\util\reader\AdbeRdr70_enu_full.exe], then select [OK]. Install Adobe Reader by following the instructions on the screen. Reinstalling B’s Recorder/B’s CLiP When reinstalling, the input Input the following serial number of a serial number has been B’s Recorder: asked B’s CLiP: Troubleshooting 28 SD Memory Card Cannot log on with the SD Memory Card Windows logon user name and password are not set in the SD Memory Card correctly. Enter the Windows user name and password without using the SD Memory Card. After logging on, set the same user name and the password on the SD Memory Card and Windows, using the following operation. • Change the setting of the SD Memory Card by [SD Card Setup] ( “SD Memory Card Security Function”) Fast User Switching Function Some applications do not work properlyWhen switching to a different user with the Fast User Switching function, the following problems may occur. • Some applications may not work properly. • Key combinations with Fn may not work. • It may not be possible to set the settings of the display. • A serial mouse may not work. • The B’s CLiP icon will no longer be shown on the taskbar and CD-RW disc cannot be written using B’s CLiP. •