Évaluations - 4, GPA: 4.3 ( )

Fabricant : Toshiba Taille : 5.58 mb Nom Fichier : Langue d'enseignement:

Do not try to remove a memory module with the computer turned on. You can damage the computer and the memory module. Do not remove the memory module while the computer is in Sleep or Hibernation mode. The computer could hang up the next time you turn it on and data in memory will be lost. In either of the above cases, the Sleep configuration will not be saved. 6 Place a soft cloth on the work surface to prevent scratching the top cover of the computer, and then place the computer upside down on the cloth. 7 Remove the main battery. For information on removing the main battery, see “Removing the battery from the computer” on page 94. NOTE To locate your memory module slot cover please refer to your Quick Start document. 8 Using a small Phillips screwdriver, loosen the screw(s) that secure the memory module slot cover. Back of computer (Sample Illustration) Removing the memory module slot cover 48 Getting Started Adding memory (optional) 9 Remove the memory module slot cover. 10 Place the screw(s) and the cover in a safe place so that you can retrieve them later. Static electricity can damage the memory module. Before you handle the module, touch a grounded metal surface to discharge any static electricity you may have built up. Avoid touching the connector on the memory module or on the computer. Grease or dust on the connector may cause memory access problems. 11 Carefully remove the new memory module from its antistatic packaging, without touching its connector. 12 Locate an empty memory module slot on the underside of the computer. If no memory slot is available, you must remove a module by performing steps 2-3 of “Removing a memory module” on page 51. If your system has the memory modules stacked on top of one another, you must remove the top module first before removing/installing the bottom module. For this model, Slot A is the bottom slot. Slot B is the top slot. If only one memory module is to be installed, it must be installed in Slot A. NOTENOTENOTE Getting Started Getting Started Adding memory (optional) 13 Pick up the memory module by its sides, avoiding any contact with its connector. Position the module toward the socket, aligning the connector’s notch with the matching key in the socket. latch latch key notch connector (Sample Illustration) Aligning the memory module with the socket 14 Firmly press the memory module into the memory slot’s socket at approximately a 30-degree angle (to the horizontal surface of the computer). (Sample Illustration) Inserting the memory module into the socket 15 Once the module’s connector is fully inserted into the socket, press downward on the top edge of the module to seat the module into the latches at the sides of the socket. These latches should “snap” into place securely with the corresponding cutouts in the side of the module. If the latches and cutouts do not line up correctly, repeat steps 14-15. 50 50 50d Adding memory (optional) latch latch (Sample Il...

Téléchargez votre

Pour télécharger, entrez 2 chiffres :