Évaluations - 1, GPA: 5 ( )

Fabricant : Husqvarna Taille : 3.55 mb Nom Fichier : Langue d'enseignement:

• Frame ground – Do not allow tools or other metal objects to contact frame when disconnecting batteries or other electrical wiring. Never allow a positive wire to touch the vehicle frame, engine, or other metal component. PERIODIC SERVICE SCHEDULES See General Warnings on page 10. y WARNING • Service, repairs, and adjustments must be made per instructions in the maintenance and service manual. NOTE: If the vehicle is constantly subjected to heavy use or severe operating conditions, the preventive maintenance procedure should be performed more often than recommended in the periodic service and lubrication schedules. Both the Periodic Service Schedule and Periodic Lubrication Schedule must be followed to keep vehicle in optimum operating condition. Page 32 2008 Husqvarna 4210-G, 4210-E, 4210-GXP, and 4210-EXP Owner’s Manual Periodic Service Schedules PERIODIC SERVICE SCHEDULE – ELECTRIC VEHICLES REGULAR INTERVAL SERVICE Daily service by owner Pre-Operation and Daily Safety Checklist See Pre-Operation and Daily SafetyChecklist on page 20. Performance Inspection See Performance Inspection on page 21. Batteries Charge batteries (after each daily use only). Weekly service by owner Batteries Check electrolyte level. Add water if necessary. See page 37. Monthly service by owneror trained technician Batteries Wash battery tops and clean terminals with baking soda/water solution. Tires Check air pressure and adjust if necessary. See Vehicle Specificationson page 50. General vehicle Wash battery compartment and underside of vehicle. Semiannual service by trainedtechnician only (or every 50 hours ofoperation, whichever comes first) Brake system Check brake shoes; replace if necessary. See Section 6 – Wheel Brake Assemblies in the appropriatemaintenance and service manual. Lubricate brake slides per Lubrication Schedule. See Section 6 – Wheel Brake Assemblies in the appropriatemaintenance and service manual. Check brake cables for damage; replace if necessary. Electrical wiring and connections Check for tightness and damage. Forward/Reverse switch Check condition of contacts and wire connections. Make sure connections are tight. Front wheel alignment and camber Check and adjust as required. See Section 7 – Steering and FrontSuspension in the appropriate maintenance and service manual. Annual service by trained technicianonly (or every 100 hours of operation, whichever comes first) Motor controller output regulator (MCOR) Check for loose hardware, cracks and other damage. Batteries If batteries are not performing as expected, see Section 13 – Batteries in the appropriate maintenance and service supplement. 2008 Husqvarna 4210-G, 4210-E, 4210-GXP, and 4210-EXP Owner’s Manual Page 33 Periodic Service Schedules PERIODIC SERVICE SCHEDULE – GASOLINE VEHICLES REGULAR INTERVAL SERVICE Daily service by owner Pre-Operation and Daily Safety Checklist See Pre-Operation and Daily SafetyChecklist on page 20. Performance Inspection See Performance Inspection on page 21. Monthly service by owneror trained technician Engine Check engine oil level; change if necessary. See Periodic Lubrication Schedules on page 35. Check engine cooling air intake; clean if necessary. Visually inspect the unshrouded area around engine exhaust for grass and debris, and clean if necessary. Tires Check air pressure and adjust as necessary. See Vehicle Specificationson page 50. General vehicle Wash engine compartment and underside of vehicle. Do not wash engine when hot. Semiannual service by trainedtechnician only (or every 50 hours ofoperation, whichever comes first) Battery Clean terminals and wash dirt from casing; check electrolyte level. See Battery – Gasoline Vehicles onpage 42. Front wheel alignment and camber Check and adjust if necessary. See Section 7 – Steering and FrontSuspension in the appropriate maintenance and service manual. Electrical wiring and connections Check for tightness and damage. Brake system Check brake shoes; replace if necessary. Lubricate brake slides. See Periodic Lubrication Schedules on page 35. Check brake cables for damage; replace if necessary. Annual service by trained technicianonly (or every 100 hours of operation, whichever comes first) Engine Check for leaks around gaskets, fill plugs, etc. Inspect, clean and regap spark plug; replace if necessary. Engine air intake system Check air filter element; clean or replace if necessary. Check clamps for tightness; check hose for cracks. General vehicle Check for loose hardware and tighten if necessary. Two year service by trained technicianonly (or every 200 hours of operation, whichever comes first) Fuel filters Replace. Dispose of used filters properly. y WARNING • If any problems are found during scheduled inspection or service, do not operate the vehicle until repairs are made. Failure to make necessary repairs could result in fire, property damage, severe personal injury, or death. Page 34 2008 Husqvarna 4210-G, 4210-E, 4210-GXP, and 4210-EXP Owner’s Manual Periodic Lu...

Téléchargez votre

Pour télécharger, entrez 2 chiffres :