Évaluations - , GPA: ( )

Instructions iOptron, Modèle SmartStar 8800

Fabricant : iOptron
Taille : 560.86 kb
Nom Fichier : 5f8b18b9-42bb-4870-ad65-de07cfe967dc.pdf

Langue d'enseignement:

Le document est chargé, s'il vous plaît patienter

Téléchargez votre Fermer

Le document est chargé, s'il vous plaît patienter

Téléchargez votre Fermer

Extend tripod legs to full extension. Step 2. Attach mount to tripod using the long bolt (#7). Slide tray on #7 bolt bottom of shaft. Then screw on round black knob (#9). #9 knob Step 3a. Note: you may use 8 AA batteries (Step 3) or the AC adaptor (Step 5) to operate the mount. Lift the battery cover. Carefully pull out the battery holder from the compartment. Be sure not to accidentally disconnect the wires. Step 3b. Insert 8 AA batteries (not included) in the holder. Refer to the diagram on the holder to orient the batteries properly. Replace the holder back into the battery compartment and replace the lid. For reference: the battery pack fits in with wires on the bottom right (See arrow in photo). Use only fresh batteries. Using old or low batteries may cause error messages. #2 knob Step 4. Attach telescope to mount using dovetail lock knob (#2). (Picture shows 80mm refractor. However all scopes will attach in the same manner.) iOptron Corp. | 6E Gill Street | Woburn, MA 01801 USA | (781) 569.0200 | Toll Free (866) 399.4587 | Plug in AC adaptor here Step 5. Plug in hand controller and AC adaptor. Plug hand controller into either one of the two HBX ports on the mount. Next plug in AC adaptor. (Or use batteries—see step 3). Turn on power (the red light should go on). At this point you can begin observing manually. Use the 4 Arrow keys (^Ў<>) to rotate the scope Up, Down, Left, and Right. Use the SPEED key to change the slew rate from the slowest (1X) to the fastest (MAX). (Note: The slowest speed on the SmartStar®-E is 2X).The next steps show you how to set up the telescope and controller for automatic slewing and tracking. Step 6. Set up telescope for auto-observing. Level the mount using the bubble on side of mount by adjusting tripod legs. The bubble should be in the middle of the circle. It is also suggested to use additional levels (such as a torpedo level) to assure precise leveling. 1) South 2) Up #4 Alt lock Step 7. Set telescope to PARK POSITION. (1) Position the mount so that the “SOUTH” mark is facing south (A compass may be helpful). (2) The telescope tube should be pointed directly up at the zenith. If it is not perfectly straight then loosen the altitude lock (#4) to adjust telescope. Step 8. Main Screen For models with GPS: Wait for controller to say “GPS-OK” or “Stop” in top right corner —not “GPS-ON”. GPS provides Latitude, Longitude, and current time only. Continue to step 9. (Please note: this picture shows the SmartStar®-G hand controller. The SmartStar®-E hand controller has similar menu items, but with a smaller 4-line screen instead.) Step 9. Press the MENU key once. Scroll (with the ^/Ў keys) to “Set Up Controller” Press ENTER. Then go to Set Up Local Time and Site in the next screen. (This may be one or two menu items depending on your version) Select and then press ENTER. Step 10. Set Up Local Time Go to: Set up Local Time (or “Local Time and Site”). Press ENTER. Enter date and day-light savings (Y-yes. ...