Check for obstructions (Wire, brake lines, fuel tank, etc.) before drilling any holes! Use hardware provided with install kit /-20 x /” Hex head bolt & /” Flat washer Spacer Bracket w/ /-20 x /” Hex head bolt & /” Flat washer Telescoping pole assembly Pole support assembly C-TCB-7-IMP-INST-12-04 SUB ASSEMBLY: 1. Confirm receipt of all hardware and components. 2. Install Chevrolet Impala Specific C-Series-IMP Consolidator® into vehicle using hardware and instructions provided. 3. Deter

Determine location to obtain both. • With offset bracket positioned against flat surface, (i.e., console, divider wall, etc.), mark and drill 5/16” hole at location of bolt on offset bracket. • Bolt offset bracket to “flat surface” using a fender washer and 5/16” nut. • Bolt C-PED1612 to floor of vehicle using /” x 1” -1 /” hex head lag bolts, depending on particular vehicle application. • Mount optional laptop mounts (C-3090 series), monitor mounts (C-3522), keyboard mounts (C-3329) or tilt

Mount C-TCB-21 into vehicle: • Position pole support assembly between seat base mount and floor of vehicle • Align holes in pole support assembly with holes in seat base. • Loosely attached factory seat bolts that were removed during subassembly. • Mount side support brace to threaded rod located on pole support assembly using a 5/16-18 Nylock nut • Mount side support brace to vehicle using H” x 1” Hex head lag bolts. A 3/16” pilot is required. Note: When mounting side support brace to flo