This accessory is designed for indoor installations in either upflow or horizontal air discharge applications. This unit is for use only on R.410A systems with thermal expansion valves. Prior to installation, study the decision tree on page 16 to confirm that all application requirements for EDA installation are met. NOTE . For downflow application, refer to Installation Instruction Supplement, Installing EDA Unit in Downflow Configuration 505,134M. Shipping & Packing List . 1 . Assembled EDA in

DrizAir Dehumidifiers DrizAir 80, DrizAir 1200, DrizAir 2000 LG, DrizAir 2400 LG 115-volt models DRI-EAZ PRODUCTS, INC. 15180 Josh Wilson Road, Burlington, WA USA 98233 Fax: (360) 757-7950 Phone: (360) 757-7776 DrizAir Dehumidifiers are commercial refrigerant dehumidifiers, designed for drying building structures and contents. They are designed for high performance water removal, as well as durability and ease of use. Read And Save These Instructions Safety Information Keep Children Away: Do not

Disconnect electrical power before servicing. CAUTION Sudden operation may cause personal injury or property damage. Unplug the dehumidifier before servicing. READ AND SAVE THESE INSTRUCTIONS I. PRINCIPLE The purpose of the Aprilaire ® Dehumidifier is to keep reduce the unwanted effects The dehumidifier gathers system and measures the condition of can activate the HVAC blower to cycle air through the dehumidifier can also operate an optional II. OPERATING INSTRUCTIONS There are three adjustable

The dehumidifier measures the condition of the house air to decide when to run. INSTALLER–PLEASENOTE! 1. INSTALLATION MUST CONFORM TO ALL APPLICABLE STATE OR LOCAL CODES. 2. A DEDICATED 15 Amp circuit is required for proper operation of the dehumidifier. If a dedicated circuit is not available, use a lightly loaded circuit. Do not use an extension cord. 3. For protection of the compressor, unit must be transported and installed in an upright position. If the unit was shipped or stored on its sid

mAINTENANCE Dehumidifier AIR FILTER Under normal circumstances, the filter in the dehumidifier should be cleaned or replaced once a year. A clean filter is necessary to prevent damage to the dehumidifier and allow it to function at full capacity. To remove the filter, first unplug or disconnect power to the dehumidifier, then remove the air filter via the access panel on the side of the dehumidifier. To clean, flush with warm water and detergent solution. After a clean or new filter is reinstall

Your dehumidifier is designed to remove humidity from your home, maintaining the humidity at a comfortable level and reducing the unwanted effects of high humidity. Use your Aprilaire Dehumidifier to control the humidity that comes into the home from opening doors and infiltration (i.e. outdoor air entering through the building envelope). You can reduce the amount of humidity that enters the home by closing windows, doors and/or fireplace flues when the outdoor humidity is high and by drying clo

The green status light below the control setting flashes when the dehumidifier is circulating the air. If the humidity of the air is higher than the setting, the compressor turns on and the green Status light is lit continuously. The dehumidifier turns off after the humidity level of the air has dropped below the setting. Optional – Heating and Cooling System Blower Operation Your installing contractor may have configured the dehumidifier to turn on the heating and cooling system blower when the

Failure to do so can cause water to back up in the pump and leak out. The control panel may signal this problem by displaying .ER9.. KEEP OUT DUST. Keep dust from drywall, demolition, and other sources out of the coils. Failure to do so can cause the unit to overheat, leading to compressor failure or other problems. Do not run the unit during sanding, painting or other operations producing airborne particulate. When dust is present, use the optional pleated paper filter to keep more dust out of