lt may be necessary to install a second dehumidifier in the enclosed area for satisfactory drying. 4. The dehumidifier must be installed on a level floor that will support it with a full bucket of water. 5. There should be a minimum of 12 inches clearance around the dehumidifier. How It Works When the unit is started, the fan begins to pull moisture-laden air across the dehumidifying coils. The coils condense or draw moisture from the air, and air flows through the side louvers into the room as

When humidity has been reduced to the comfort level set on the control, the unit turns off. When first using dehumidifier, turn Humidistat Control clockwise to MAX.DRY. Unit will run continuously at this setting. Operate dehumidifier at the MAX.DRY setting for three to four days. During this time, observe the dampness conditions in the area being dried. When the sweating has stopped and the dampness odors are gone, adjust Humidistat Control to the position between OFF and MAX.DRY that provides a

• Your dehumidifier must be plugged directly into a properly grounded and polarized three-prong receptacle. If the wall receptacle you intend to use will not accept a three-prong plug, or if you are not sure the outlet is adequately grounded or protected by a time delay fuse or circuit breaker, have a qualified electrician install the proper outlet according to the National Electrical Code and applicable local codes and ordinances. Do n nnot u uuse a aan e eextension c ccord o oor a aan adapter

The unit will cycle on and off keeping the desired level of comfort. ................ 4 4. To shut the unit down, rotate the HUMIDITY knob to the OFF position. Note: the power indicator will still be lit when the unit is turned off. Only removing the plug will extinguish these lights. REMOVING COLLECTED WATER 1. Emptying the Bucket: a. When the bucket is full the unit will shut down and the BUCKET FULL indicator light will illuminate. b. Do not move the unit at this point otherwise water may spi

4. You can also use the FAN button to change the fan speed to HIGH( ) or LOW( ). The indicator light will show the setting you have selected. A higher fan speed will result in quicker moisture removal. 5. The FILTER RESET light will illuminate after 250 hours of operation. At this time refer to the Care and Cleaning section to remove and clean the filter. Once the filter has been cleaned , to extinguish the light simply press the FILTER button. 5 6. The TIMER function enables you to either start

All warranties are made by Electrolux. This warranty applies only in the 50 states of the U.S.A., Puerto Rico and Canada. 2 Important Safety Instructions Avoid fire hazard or electric shock. Do not use an extension cord or an adaptor plug. Do not remove grounding prong from power cord. Grounding t tt ype w all r rr eceptacle Do n nn ot, u uu nder any c cc ircumstances, cut, r rr emove, or b bb ypass t tt he grounding p pp rong from t tt his p pp lug. Read a aall i iinstructions b bbefore u uusin

Do not pinch, bend, or knot the power cord. SAFETY PRECAUTIONS SAFETY PRECAUTIONS Do not direct airflow at fireplaces or other heat related sources as this could cause flare ups. Do not climb on or place objects on the unit. Do not hang objects off the unit. Do not place containers with liquids on the unit. Turn off the dehumidifier at the power source when it will not be used for an extended period of time. Operate the unit with air filter in place. Do not block or cover the intake grille, disc

6 Location .............................................................. 3 Storage ............................................................. 6 How It Works....................................................... 3 Before You Call ................................................... 7 Operating Instructions .......................................... 4-6 Major Appliance Warranty ................................... 8 2020264A0525 USA 1-800-944-9044 Canada 1-800-265-8352 Important Safety Instruct