Évaluations - 3, GPA: 4
(
)
)
|
Facilité d'utilisation
Warning! Never attempt to replace the charger unit with a regular mains plug. Use your Black & Decker charger only to charge the battery in the tool with which it was supplied. Other batteries could burst, causing personal injury and damage. Have defective cords replaced immediately. Do not expose the charger to water. Do not open the charger. Do not probe the charger. The spotlight must be placed in a well ventilated area when charging. All batteries lose charge with time, specially when they are warm. Recharge the unit every two months for 24 hours when not in frequent use. If the unit is not going to be used for extended periods, disconnect the charger and store in a cool, dry place. The following symbols are found on your charger: Your charger is double insulated; therefore no earth wire is required. Read all of this instruction manual carefully. This appliance is intended for indoor use only 130oC The charger automatically shuts off if the ambient temperature becomes too high. As a consequence the charger will be inoperable. The charging base must be disconnected from the mains supply and taken to an authorised service centre for repair. This product must not be disposed of with normal household waste. Electrical safety Your charger is double insulated; therefore no earth FEATURES This appliance includes some or all of the following features: 1. Rubber ring guard 2. Charge LED 3. Charging socket 4. Carry lanyard 5. Trigger switch 6. Charger jack plug 7. Mains charging adaptor Charging the spotlight This spotlight is shipped in a partially charged state. Charge the spotlight before first use using the mains charging adaptor (7) for 18 hours. Warning! Do not charge for longer than 48 hours. Insert the charger jack plug (6) into the charging socket (3). Insert the mains charging adaptor (7) into a mains power socket. The red charge LED (2) will light when the unit is charging. USE Before operating the spotlight remove the charger jack plug (6) from the charging socket (3). Using the built-in carry lanyard The carry lanyard (4) may be used to store or carry the spotlight. Adjust the slide on the cords to keep the lanyard secure around the supporting object. wire is required. Always check that the main voltage corresponds to the voltage on the rating plate. Warning! If the power cord is damaged, it must be replaced by the manufacturer, authorized Black & Decker Service Center or an equally qualified person in order to avoid damage or injury. If the power cord is replaced by an equally qualified person, but not authorized by Black & Decker, the warranty will not be valid. 9 ENGLISH MAINTENANCE SERVICE INFORMATION Your Black & Decker tool has been designed to operate over a long period of time with a minimum of maintenance. Continuous satisfactory operation depends upon proper tool care and regular cleaning. Warning! Before performing any maintenance or cleaning on the appliance, unplug the appliance. From time to time wipe the appliance with a damp cloth. Do not use any abrasive or solvent-based cleaner. Do not immerse the appliance in water. PROTECTING THE ENVIRONMENT Separate collection. This product must not be disposed of with normal household waste. Should you find one day that your appliance needs replacement, or if it is of no further use to you, think of the protection of the environment. Black & Decker repair agents will accept old Black & Decker tools and ensure that they are disposed of in an environmentally safe way. Separate collection of used products and packaging allows materials to be recycled and used again. Re-use of recycled materials helps prevent environmental pollution and reduces the demand for raw materials Local regulations may provide for separate collection of electrical products from the household, at municipal waste sites or by the retailer when you purchase a new product. Black & Decker batteries can be recharged many times. At the end of their useful life, discard batteries with due care for our environment: Do not short-circuit the battery terminals. Do not dispose of the battery in fire, as this may result in an explosion. Be aware that the battery is heavy. Run the battery down completely, then remove it from the appliance. NiCd, NiMh, Lithium Ion and Lead Acid (Pb) batteries are recyclable. They must not be disposed of with household waste. Place the battery in suitable packaging to ensure that the terminals cannot be shortcircuited. Take the battery to any authorised repair agent or a local recycling station. Black & Decker offers a full network of company-owned and authorized service locations. All Black & Decker Service Centers are staffed with trained personnel to provide customers with efficient and reliable power tool service. For more information about our authorized service centers and if you need technical advice, repair, or genuine factory replacement parts, contact the Black & Decker location nearest you, or visit us at SPECIFICATIONS B...