Log:
Évaluations - 2, GPA: 3.5 ( )

Instructions Philips, Modèle ACT 7585

Fabricant : Philips
Taille : 2.34 mb
Nom Fichier : a5ab566d-6dc4-4b14-abdb-f3532524233c.pdf
Langue d'enseignement: enesfrpt
Aller à la télécharger



Facilité d'utilisation


1 Switch the slider to HOLD to activate HOLD. y All buttons are locked. HOLD is shown when you press any button. If the set is switched off, HOLD will be shown only when 2; is pressed. 2 To deactivate HOLD, switch the slider to OFF. Note: If you deactivate HOLD by switching the slider to RESUME, you will be activating theRESUME function. 17 FEATURES ESP English Conventional portable CD-or vibration during playback often of the CD. The ELECTRONIC SKIP PROTECTION (ESP) feature, with which your set is equipped, however, prevents such loss of continuity when your player is subjected But ESP does not prevent playback interruptions vigorous exercise. Nor does it protect against resulting from the player being dropped! • Press ESP during playback to activate the skip protection. y ESP is shown and the protection is activated. • To deactivate the skip protection, press ESP again. y ESP goes off and the protection is deactivated. ESP ESP 18 IN-CAR In-car use (connections supplied 4,5 V DC DIGITALDIGITAL DIGITAL PROG MODE DBB ESP P / LINE OUT VOL OFF RESUME HOLD English Only use the AY 3545 car voltage converter (4.5V, DC, positive pole to the centre pin) and the AY 3501 car cassette adapter. Any other product may damage the set. 1 Put the CD-player on a horizontal, vibration-free and stable surface. Make sure it is in a safe place, where the player is neither a danger nor obstacle to either driver or passenger. 2 Connect the DC plug of the voltage converter to the 4.5V DC socket player (only for a 12 V car battery,negative grounding) . 3 Insert the voltage converter into the cigarette lighter socket. If necessary, clean the cigarette lighter socket to obtain a good electrical contact. 4 Turn down the volume and connect the cassette adapter plug to the p/ LINE OUT socket of the CD player. 5 Carefully insert the cassette adapter into the car radio’s cassette compartment. 6 Make sure the cord does not hinder your driving. 7 Start the CD-player, set VOL E to position 8 and adjust the sound with the car radio controls. • Always remove the voltage converter from the cigarette lighter socket when the CD-player is not in use. Note: –Avoid excessive heat from the car heating or from direct sunlight (e.g. in a parked car in the summer). – If your car radio has a LINE IN socket, it is better to use this instead of the cassette adapter. Simply connect a signal lead from thep/ LINE OUT socket of the CD-player to this LINEIN socket. 19 TROUBLESHOOTING English WARNING Under no circumstances should you try to repair the set yourself as this will invalidate the guarantee. Problem Possible cause Solution No power, Batteries playback does Batteries inserted incorrectly Insert the batteries not start correctly. Batteries are empty. Change the batteries. Contact pins are dirty. Clean them with a cloth. Mains adapter Loose connection Connect the adapter securely. In-car use Cigarette lighter is not powered Switch on ignition or insert when ignition is off. batteries. nF dISC CD-RW (CD-R) is not recorded Use FINALIZE on the indication properly. CD recorder to complete the recording. no dISC The CD is badly Replace or clean the CD. indication scratched or dirty. CD is not or incorrectly inserted. Insert a CD, label upwards. The laser lens is steamed up. Wait until the lens has cleared. HOLD indication HOLD is activated. Deactivate HOLD. and/or no reaction Electrostatic discharge Disconnect the set from to controls power supply or take out the batteries for a few seconds. 20 TROUBLESHOOTING If a fault occurs, first If you are unable to solve service centre. Problem Possible cause Solution The CD skips tracks. The CD is damaged or dirty. Replace or clean the CD. RESUME, SHUFFLE or PROGRAM is Switch RESUME, SHUFFLE active. or PROGRAM off. No sound or PAUSE is activated. Press 2; . bad sound quality Loose, wrong or dirty Check and clean connections connections. Volume is not adjusted. Adjust the volume. Malfunctions due to nearness Keep the player away from of active mobile phones active mobile phones. Strong magnetic fields near Change the player’s position the player or connections. In-car use cassette adapter is Insert the cassette adapter inserted incorrectly. correctly. Temperature inside the car Let the player adjust to the is too high/low. temperature. Cigarette lighter socket Clean the cigarette is dirty. lighter socket. Wrong playback direction of the Change the autoreverse car cassette player’s direction. autoreverse feature CAUTION Use of controls or adjustments or performance of procedures other than herein may result in hazardous radiation exposure or other unsafe operation. English 21 GENERAL CD-player and English • Do not touch the lens A of the CD-player. • Do not expose the set, batteries rain, sand or excessive heat (caused equipment or direct sunlight). • You can clean the CD-player with a soft, dampened, lint-free cloth. Do not use any agents as they may have a corrosive effect. A • To clean the CD, wipe it in a straight li...

Ce manuel est également adapté pour les modèles :
Lecteurs - ACT7585/00 (2.34 mb)

Écrivez votre propre critique du dispositif



Texte du message
Votre nom :
Entrez les deux chiffres :
capcha





catégories